Search results
Results from the WOW.Com Content Network
An elevated water tank, also known as a water tower, will create a pressure at the ground-level outlet of 1 kPa per 10.2 centimetres (4.0 in) or 1 psi per 2.31 feet (0.70 m) of elevation. Thus a tank elevated to 20 metres creates about 200 kPa and a tank elevated to 70 feet creates about 30 psi of discharge pressure, sufficient for most ...
To calculate the weight of the displaced water, it is necessary to know its density. Seawater (1,025 kg/m 3) is more dense than fresh water (1,000 kg/m 3); [5] so a ship will ride higher in salt water than in fresh. The density of water also varies with temperature.
Then scrub the inside of the tank with a detergent, and hot water mixture. [16] Disinfect: Fill the tank a quarter full with clean water. Sprinkle 80 grams of granular high-strength calcium hypochlorite (HSCH) into the tank for every 1000 litres total capacity of the tank. Fill the tank completely with clean water, close the lid and leave to ...
Several methods of such measuring exist. In one case the increase of liquid level is registered as the object is immersed in the liquid (usually water). In the second case, the object is immersed into a vessel full of liquid (called an overflow can), causing it to overflow. Then the spilled liquid is collected and its volume measured.
SG is the specific gravity of the fluid (for water = 1), ΔP is the pressure drop across the valve (expressed in psi). In more practical terms, the flow coefficient C v is the volume (in US gallons) of water at 60 °F (16 °C) that will flow per minute through a valve with a pressure drop of 1 psi (6.9 kPa) across the valve.
The Union Watersphere is a water tower topped with a sphere-shaped water tank in Union, New Jersey, [11] and characterized as the World's Tallest Water Sphere. A Star Ledger article [ 12 ] suggested a water tower in Erwin, North Carolina completed in early 2012, 219.75 ft (66.98 m) tall and holding 500,000 US gallons (1,900 m 3 ), [ 13 ] had ...
One would not want the water table to be too shallow to avoid crop yield depression nor too deep to avoid drought conditions. This is a subject of drainage research. The figure shows that a seasonal average depth of the water table shallower than 70 cm causes a yield depression [5] The figure was made with the SegReg program for segmented ...
A percolation test (colloquially called a perc test) is a test to determine the water absorption rate of soil (that is, its capacity for percolation) in preparation for the building of a septic drain field (leach field) or infiltration basin. [1] The results of a percolation test are required to design a septic system properly.