Search results
Results from the WOW.Com Content Network
DO-160, Environmental Conditions and Test Procedures for Airborne Equipment is a standard for the environmental testing of avionics hardware. It is published by the Radio Technical Commission for Aeronautics (RTCA) and supersedes DO-138.
The EPA Federal Test Procedure, commonly known as FTP-75 for the city driving cycle, are a series of tests defined by the US Environmental Protection Agency (EPA) to measure tailpipe emissions and fuel economy of passenger cars (excluding light trucks and heavy-duty vehicles).
The International Follow-On Structural Fatigue Test Program (IFOSTP) was a joint venture between Australia, Canada and the U.S. to fatigue test the F/A-18 Hornet. The Australian test involved the use of electrodynamic shakers and pneumatic airbags to simulate high angle of attack buffet loads over the empennage. [13] [14]
ISO 8178 is a collection of steady state test cycles used for defining emission standards for non-road engines in the European Union, United States, Japan and other countries. Test cycle ISO 8178 C1 is also referred to as "Non-Road Steady Cycle" and used extensively.
A hydrostatic test involves pressurising the cylinder to its test pressure (usually 5/3 or 3/2 of the working pressure) and measuring its volume before and after the test. A permanent increase in volume above the tolerated level means the cylinder fails the test and must be permanently removed from service. [3]: sect. 5.7.3
Pneumatic logic is a reliable and functional control method for industrial processes. In recent years, these systems have largely been replaced by electronic control systems in new installations because of the smaller size, lower cost, greater precision, and more powerful features of digital controls.
Modulating control valves each with 4-20mA I to P converter linked to pneumatic a valve positioner controlling a diaphragm actuator. An air-operated valve, also known as a pneumatic valve, is a type of power-operated pipe valve that uses air pressure to perform a function similar to a solenoid.
Part 4: Requirements and test procedures for aerodynamics on open track; Part 5: Requirements and test procedures for aerodynamics in tunnels; Part 6: Requirements and test procedures for cross wind assessment; EN 14081: Timber structures - Strength graded structural timber with rectangular cross section Part 1: General requirements