Search results
Results from the WOW.Com Content Network
In a series circuit, the current that flows through each of the components is the same, and the voltage across the circuit is the sum of the individual voltage drops across each component. [1] In a parallel circuit, the voltage across each of the components is the same, and the total current is the sum of the currents flowing through each ...
Parallel versus serial communication In data transmission , parallel communication is a method of conveying multiple binary digits ( bits ) simultaneously using multiple conductors. This contrasts with serial communication , which conveys only a single bit at a time; this distinction is one way of characterizing a communications link .
An RLC circuit is an electrical circuit consisting of a resistor (R), an inductor (L), and a capacitor (C), connected in series or in parallel. The name of the circuit is derived from the letters that are used to denote the constituent components of this circuit, where the sequence of the components may vary from RLC.
series and parallel circuits Electrical circuits where current passes through multiple elements either one after the other, or side by side, like the rungs of a ladder, or both. shaded-pole motor An alternating current single-phase motor that produces a rotating magnetic field by a turn of wire around part of a field pole. shaft voltage
A parallel resonant circuit can be used as load impedance in output circuits of RF amplifiers. Due to high impedance, the gain of amplifier is maximum at resonant frequency. Both parallel and series resonant circuits are used in induction heating. LC circuits behave as electronic resonators, which are a key component in many applications ...
A bridge-parallel amplifier topology is a hierarchical combination of the bridged and paralleled amplifier topologies, with at least four single-ended channels needed to produce one bridge-parallel channel. The two topologies complement each other in that the bridging allows for higher voltage output and the paralleling provides the current ...
Definition 1. Finally, a graph is called series–parallel (SP-graph), if it is a TTSPG when some two of its vertices are regarded as source and sink. In a similar way one may define series–parallel digraphs, constructed from copies of single-arc graphs, with arcs directed from the source to the sink.
Equivalent circuits can be used to electrically describe and model either a) continuous materials or biological systems in which current does not actually flow in defined circuits or b) distributed reactances, such as found in electrical lines or windings, that do not represent actual discrete components. [5]