Search results
Results from the WOW.Com Content Network
A drainage equation is an equation describing the relation between depth and spacing of parallel subsurface drains, depth of the watertable, depth and hydraulic conductivity of the soils. It is used in drainage design. Parameters in Hooghoudt's drainage equation. A well known steady-state drainage
The energy balance of groundwater flow can be applied to flow of groundwater to subsurface drains. [2] The computer program EnDrain [3] compares the outcome of the traditional drain spacing equation, based on Darcy's law together with the continuity equation (i.e. conservation of mass), with the solution obtained by the energy balance and it can be seen that drain spacings are wider in the ...
According to Montgomery and Dietrich’s equation, drainage density is a function of vertical hydraulic conductivity. Coarse-grained sediment like sand would have a higher hydraulic conductivity and are predicted by the equation to form a relatively higher drainage density system than a system formed by finer silt with a lower hydraulic ...
Spacing equations of subsurface drains and the groundwater energy balance applied to drainage equations [5] are examples of two-dimensional groundwater models. Three-dimensional models like Modflow [6] require discretization of the entire flow domain. To that end the flow region must be subdivided into smaller elements (or cells), in both ...
Darcy's law is an equation that describes the flow of a fluid through a porous medium and through a Hele-Shaw cell.The law was formulated by Henry Darcy based on results of experiments [1] on the flow of water through beds of sand, forming the basis of hydrogeology, a branch of earth sciences.
The main conclusion of the study was that the HBV model can be used to predict material transport on the scale of the drainage basin during stationary conditions, but cannot be easily generalised to areas not specifically calibrated. In a different work, Castanedo et al. applied an evolutionary algorithm to automated watershed model calibration ...
The interception rate of channel drainage is greater than point drainage and the excavation required is usually much less deep. The surface opening of channel drainage usually comes in the form of gratings (polymer, plastic, steel or iron) or a single slot (slot drain) that run along the ground surface (typically manufactured from steel or iron).
Flux F through a surface, dS is the differential vector area element, n is the unit normal to the surface. Left: No flux passes in the surface, the maximum amount flows normal to the surface.