enow.com Web Search

  1. Ads

    related to: 8 ohm speakers 6x9

Search results

  1. Results from the WOW.Com Content Network
  2. Thiele/Small parameters - Wikipedia

    en.wikipedia.org/wiki/Thiele/Small_parameters

    This standard is voluntary, and many 8-ohm drivers have resistances of ≈5.5 ohms, and proportionally lower for lower rated impedances. Measured in henries (H), this is the inductance of the voice coil. The voice coil is a lossy inductor, in part due to losses in the pole piece, so the apparent inductance changes with frequency.

  3. Electrical characteristics of dynamic loudspeakers - Wikipedia

    en.wikipedia.org/wiki/Electrical_characteristics...

    Sixteen ohm drivers (or loudspeakers systems) would be connected to the 16-ohm tap, 8 ohm to the 8 ohm tap, etc. This is significant since the ratio between the loudspeaker impedance and the amplifier's impedance at a particular frequency provides damping (i.e., energy absorption) for the back EMF generated by a driver.

  4. Pioneer SX-1980 - Wikipedia

    en.wikipedia.org/wiki/Pioneer_SX-1980

    The Pioneer SX-1980 [1] [2] [3] is an AM/FM radio receiver that Pioneer Corporation introduced in 1978, to be matched with the HPM series of speakers. It was rated at 270 watts RMS per channel into 8 ohms , both channels driven.

  5. Speaker wire - Wikipedia

    en.wikipedia.org/wiki/Speaker_wire

    [citation needed] High-power in-car audio systems using 2-ohm speaker circuits require thicker wire than 4 to 8-ohm home audio applications. Most consumer applications use two conductor wire. A common rule of thumb is that the resistance of the speaker wire should not exceed 5 percent of the rated impedance of the system.

  6. Damping factor - Wikipedia

    en.wikipedia.org/wiki/Damping_factor

    The E-202 has a Speaker Damping Control which permits choice of three damping factors and induces maximum potential performance from any speaker. Damping factor with an 8 Ω load becomes more than 50 when this control is set to NORMAL. Likewise, it is 5 at MEDIUM position, and 1 at SOFT position. It enables choosing the speaker sound that one ...

  7. Line level - Wikipedia

    en.wikipedia.org/wiki/Line_level

    Connecting a low-impedance load such as a loudspeaker (usually 4 to 8 Ω) to a line out will essentially short circuit the output circuit. Such loads are around 1/1000 the impedance a line out is designed to drive, so the line out is usually not designed to source the current that would be drawn by a 4 to 8 ohm load at normal line out signal ...

  1. Ads

    related to: 8 ohm speakers 6x9