enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Tensioner - Wikipedia

    en.wikipedia.org/wiki/Tensioner

    Chain tensioner on a single-speed bicycle Belt tensioner on a belt-drive bicycle Hydraulic bolt tensioner Hydraulic Puller-tensioner . A tensioner is a device that applies a force to create or maintain tension. The force may be applied parallel to, as in the case of a hydraulic bolt tensioner, or perpendicular to, as in the case of a spring ...

  3. Belt-driven bicycle - Wikipedia

    en.wikipedia.org/wiki/Belt-driven_bicycle

    Gates bike belt drive system Belt-drive Belt-drive single-speed rear hub on a Trek District Belt-drive crankset on a Trek District Belt-drive multi-speed rear hub gear on a Trek Soho. A belt-driven bicycle is a chainless bicycle that uses a flexible belt, typically a synchronous toothed design, in order to transmit power from the pedals to the ...

  4. List of bicycle parts - Wikipedia

    en.wikipedia.org/wiki/List_of_bicycle_parts

    Fork end: paired slots on a fork or frame at which the axle of the wheel is attached. See also Dropout; Frame: the mechanical core of a bicycle, the frame provides points of attachment for the various components that make up the machine. The term is variously construed, and can refer to the base section, always including the bottom bracket, or ...

  5. Bicycle frame - Wikipedia

    en.wikipedia.org/wiki/Bicycle_frame

    Track frames have much in common with road and time trial frames, but come with horizontal, rear-facing, rear fork ends, [40] rather than dropouts, [41] to allow one to adjust the position of the rear wheel horizontally to set the proper chain tension. Rear hub spacing is 120 millimetres (4.7 in) rather than 130 millimetres (5.1 in) or more for ...

  6. Belt (mechanical) - Wikipedia

    en.wikipedia.org/wiki/Belt_(mechanical)

    The ideal belt is that of the lowest tension that does not slip in high loads. Belt tensions should also be adjusted to belt type, size, speed, and pulley diameters. Belt tension is determined by measuring the force to deflect the belt a given distance per inch (or mm) of pulley.

  7. FEMA employee fired for urging team to not help homes with ...

    www.aol.com/news/fema-employee-fired-urging-team...

    The U.S. Federal Emergency Management Agency - whose mission is to help people before, during and after disasters - fired an employee who advised her survivor assistance team in Florida to not go ...

  8. Mortgage and refinance rates for Oct. 30, 2024: Average 30 ...

    www.aol.com/finance/mortgage-and-refinance-rates...

    Editor's note: Rates shown are as of Wednesday, October 30, 2024, at 6:15 a.m. ET. APYs and promotional rates for some products can vary by region and are subject to change.

  9. Belt tensioner - Wikipedia

    en.wikipedia.org/?title=Belt_tensioner&redirect=no

    This page was last edited on 30 January 2012, at 22:03 (UTC).; Text is available under the Creative Commons Attribution-ShareAlike 4.0 License; additional terms may apply.