enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Regenerative circuit - Wikipedia

    en.wikipedia.org/wiki/Regenerative_circuit

    Regenerative receivers require fewer components than other types of receiver circuit, such as the TRF and superheterodyne. The circuit's advantage was that it got much more amplification (gain) out of the expensive vacuum tubes , thus reducing the number of tubes required and therefore the cost of a receiver.

  3. Squegging - Wikipedia

    en.wikipedia.org/wiki/Squegging

    The receiver sensitivity rises while the oscillation builds up. The oscillation stops when the operation point no longer fulfills the Barkhausen stability criterion. The blocking oscillator recovers to the initial state and the cycle starts again. [2] The receive frequency of the Armstrong Super-Regenerative receiver was some hundred kilohertz.

  4. History of radar - Wikipedia

    en.wikipedia.org/wiki/History_of_radar

    The receiver was then rebuilt, becoming a super-regenerative set with two intermediate-frequency stages. With this improved receiver, the system readily tracked vessels at up to 8 km (5.0 mi) range. In September 1935, a demonstration was given to the Commander-in-Chief of the Kriegsmarine. The system performance was excellent; the range was ...

  5. Radio receiver design - Wikipedia

    en.wikipedia.org/wiki/Radio_receiver_design

    The regenerative receiver also had its heyday at the time where adding an active element (vacuum tube) was considered costly. In order to increase the gain of the receiver, positive feedback was used in its single RF amplifier stage; this also increased the selectivity of the receiver well beyond what would be expected from a single tuned circuit.

  6. Talk:Superheterodyne receiver - Wikipedia

    en.wikipedia.org/wiki/Talk:Superheterodyne_receiver

    References ^ "Why it is preferred to have local oscillator frequency larger than carrier frequency in superheterodyne receiver?". electronics.stackexchange.com. Retrieved 4 February 2019. Double tuned Superheterodyne receivers usually contain double tuned circuits (sets of two loosely coupled circuits) as filters in IF receiver - this is because such a filter has almost flat band instead a ...

  7. WD-11 - Wikipedia

    en.wikipedia.org/wiki/WD-11

    The WD-11 vacuum tube, a triode, was introduced by the Westinghouse Electric corporation in 1922 for their Aeriola RF model radio and found use in other contemporary regenerative receivers (used as a detector-amplifier) including the Regenoflex and Radiola series.

  8. Bahamas 'firmly rejected' Trump proposal to deport immigrants ...

    www.aol.com/bahamas-firmly-rejected-trump...

    The Bahamas has “firmly rejected” President-election Donald Trump's proposal to fly deported immigrants out of the U.S. and into the small island nation about 100 miles southeast of Florida ...

  9. Audion receiver - Wikipedia

    en.wikipedia.org/wiki/Audion_receiver

    C1 is the gridleak capacitor. C2 is a radio frequency bypass capacitor. L4 is an inductance without inductive coupling to L. Together with the tube internal capacitor between anode and grid L4 creates a negative differential resistance at the grid. Regenerative control is as in Fig. 8. Fig. 10 AM band NPN audion receiver