enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Circulation evaporator - Wikipedia

   en.wikipedia.org/wiki/Circulation_evaporator

   The evaporator uses separate parts to create the overall system; a heat exchanger, separation tank and for the forced circulation system (as opposed to the natural circulation system) a circulation pump are standard although can be subject to change depending on the liquids properties of the mixtures being separated and specific design.

3. Parts washer - Wikipedia

   en.wikipedia.org/wiki/Parts_washer

   A solvent style parts washer is filled with several gallons of solvent that is stored in a settling pan at the bottom of the washer. A small flame-tight electric liquid pump is immersed in the solvent and skims clean solvent from near the top of the settling tank, and pumps it at low pressure through a stiff flexible nozzle onto a metal grating ...

4. Vacuum ejector - Wikipedia

   en.wikipedia.org/wiki/Vacuum_Ejector

   A vacuum ejector, or simply ejector, is a type of vacuum pump, which produces vacuum by means of the Venturi effect.. In an ejector, a working fluid (liquid or gaseous) flows through a jet nozzle into a tube that first narrows and then expands in cross-sectional area.

5. Mixer-settler - Wikipedia

   en.wikipedia.org/wiki/Mixer-settler

   The mechanical agitator is equipped with a motor which drives a mixing and pumping turbine. This turbine draws the two phases from the settlers of the adjacent stages, mixes them, and transfers this emulsion to the associated settler. The mixer may consists of one or multiple stages of mixing tanks.

6. Luigi Mangione's Lawyer Told Him in Court: 'Don't Say a Word ...

   www.aol.com/lifestyle/luigi-mangiones-lawyer...

   Luigi Mangione, the man accused of murdering UnitedHealthcare CEO Brian Thompson, was told "don't say a word" by his lawyer in court, following an outburst outside the hearing at a Pennsylvania ...

7. Cold trap - Wikipedia

   en.wikipedia.org/wiki/Cold_trap

   Cold traps (C in the figure) usually consist of two parts: The bottom is a large, thick round tube with ground-glass joints (B in the figure), and the second is a cap (A in the figure), also with ground-glass connections. The length of the tube is usually selected so that, when assembled, the total reached is about half the length of the tube.