Ad
related to: standard height of ceiling from floor line 6 panel wall design details
Search results
Results from the WOW.Com Content Network
Partial height wall, a low wall that doesn't extend all the way up to the ceiling. Thin solid lines are used for built-in structures (such as cabinets, bookshelves, or plumbing fixtures). Thin dotted lines indicate overhead features, such as wall cabinets in a kitchen or a special ceiling treatment or an archway in the living room. North arrow ...
To wainscot [waegenschotten, Dutch], to line the walls with boards A 'wainscot' was therefore a board of riven (and later quarter-sawn ) oak, and wainscoting was the panelling made from it. During the 18th century, oak wainscot was almost entirely superseded for panelling in Europe by softwoods (mainly Scots pine and Norway spruce ), but the ...
It is also called a plan which is a measured plane typically projected at the floor height of 4 ft (1.2 m), as opposed to an elevation which is a measured plane projected from the side of a building, along its height, or a section or cross section where a building is cut along an axis to reveal the interior structure.
An architectural drawing or architect's drawing is a technical drawing of a building (or building project) that falls within the definition of architecture.Architectural drawings are used by architects and others for a number of purposes: to develop a design idea into a coherent proposal, to communicate ideas and concepts, to convince clients of the merits of a design, to assist a building ...
Typically the knee wall is covered with plaster or gypsum board. The term is derived from the association with a human knee, partly bent. Knee walls are common in houses in which the ceiling on the top floor is an attic, i.e. the ceiling is the underside of the roof and slopes down on one or more sides.
Extensive use is made of floor-to-ceiling glass, enabling light to penetrate deeper into the building, thus maximizing floor space. Glass curtain wall of Bauhaus Dessau, 1926. Historically, buildings were constructed of timber, masonry, or a combination of both. Their exterior walls were load-bearing, supporting much or all of the load of the ...
Typical U.S. height for panels is 8 or 9 feet (2.4 or 2.7 m). Panels come in widths ranging from 4 to 12 inches (100–300 mm) thick and a rough cost is $4–$6/ft 2 in the U.S. [ 5 ] In 4Q 2010, new methods of forming radius, sine curve, arches and tubular SIPs were commercialized.
A typical temporary wall can be constructed with 1⁄2" (6 mm) to 5⁄8" (16 mm) sheet rock (plasterboard), metal 2 × 3s (approx. 5 × 7 cm), or 2 × 4s, or taped, plastered and compounded. Most installation companies use lattice (strips of wood) to cover the joints of the temporary wall with the ceiling.
Ad
related to: standard height of ceiling from floor line 6 panel wall design details