Search results
Results from the WOW.Com Content Network
The physical phenomena on which the device relies (such as spinning platters in a hard drive) will also impose limits; for instance, no spinning platter shipping in 2009 saturates SATA revision 2.0 (3 Gbit/s), so moving from this 3 Gbit/s interface to USB 3.0 at 4.8 Gbit/s for one spinning drive will result in no increase in realized transfer rate.
A test with DDR and DDR2 RAM in 2005 found that average power consumption appeared to be of the order of 1–3 W per 512 MB module; this increases with clock rate and when in use rather than idling. [14]
DRAM load on the command/address (CA) bus can be reduced by using registered memory. [citation needed] Predating the term rank (sometimes also called row) is the use of single-sided and double-sided modules, especially with SIMMs. While most often the number of sides used to carry RAM chips corresponded to the number of ranks, sometimes they ...
DDR4 RAM operates at a voltage of 1.2 V and supports frequencies between 800 and 1600 MHz (DDR4-1600 through DDR4-3200). Compared to DDR3, which operates at 1.5 V with frequencies from 400 to 1067 MHz (DDR3-800 through DDR3-2133), DDR4 offers better performance and energy efficiency. DDR4 speeds are advertised as double the base clock rate due ...
PC133 refers to SDR SDRAM operating at a clock frequency of 133 MHz, on a 64-bit-wide bus, at a voltage of 3.3 V. PC133 is available in 168-pin DIMM and 144-pin SO-DIMM form factors. PC133 is the fastest and final SDR SDRAM standard ever approved by the JEDEC, and delivers a bandwidth of 1.066 GB per second ([133.33 MHz * 64/8]=1.066 GB/s).
Four PCI Express bus card slots (from top to second from bottom: ×4, ×16, ×1 and ×16), compared to a 32-bit conventional PCI bus card slot (very bottom). In computer architecture, a bus [1] (historically also called data highway [2] or databus) is a communication system that transfers data between components inside a computer, or between computers.
Peanut Butter Blossoms. As the story goes, a woman by the name of Mrs. Freda F. Smith from Ohio developed the original recipe for these for The Grand National Pillsbury Bake-Off competition in 1957.
The ExpressCard has a maximum throughput of 2.5 Gbit/s through PCI Express and 480 Mbit/s through USB 2.0 dedicated for each slot, while all CardBus and PCI devices connected to a computer usually share a total 1.06 Gbit/s bandwidth. The ExpressCard standard specifies voltages of either 1.5 V or 3.3 V; CardBus slots can use 3.3 V or 5.0 V.