Search results
Results from the WOW.Com Content Network
Part 2-030: Particular requirements for equipment having testing or measuring circuits; Part 2-031: Safety requirements for hand-held and hand-manipulated probe assemblies for electrical test and measurement; Part 2-032: Particular requirements for hand-held and hand-manipulated current sensors for electrical test and measurement
IEC 60204-1 / EN 60204 Safety of machinery – Electrical equipment of machines – Part 1: General requirements This is a standard published by the International Electrotechnical Commission (IEC), published in parallel by CENELEC ( European Committee for Electrotechnical Standardization ).
The electrical safety develops with the technical progress. In 1989 OSHA [1] promulgated a much-needed regulation in the General Industry Regulations. Several standards are defined for control of hazardous energy, or lockout/tagout. In 1995 OSHA was successful in promulgation of regulations for utility. [2]
IEC 61010 Safety requirements for electrical equipment for measurement, control, and laboratory use; IEC 61012 Filters for the measurement of audible sound in the presence of ultrasound; IEC 61014 Programmes for reliability growth; IEC TR 61015 Brush-holders for electrical machines. Guide to the measurement of the static thrust applied to brushes
English: These Regulations consolidate with amendments the Low Voltage Electrical Equipment (Safety) Regulations 1989 (the “1989 Regulations”). They implement the requirements of Council Directive No. 73-23-EEC (OJ No. L77, 26.3.1973, p.29) on the harmonisation of the laws of member States relating to electrical equipment designed for use within certain voltage limits, as amended by ...
The general standard IEC 60601-1 – Medical electrical equipment – Part 1: General requirements for basic safety and essential performance – gives general requirements of the series of standards. 60601 is a widely accepted benchmark for medical electrical equipment and compliance with IEC60601-1 has become a requirement for the commercialisation of electrical medical equipment in many ...
Unlike ATEX which uses numbers to define the safety "Category" of equipment (namely 1, 2, and 3), the IEC continued to utilise the method used for defining the safe levels of intrinsic safety namely "a" for zone 0, "b" for zone 1 and "c" for zone 2 and apply this Equipment Level of Protection to all equipment for use in hazardous areas since ...
MOPP safety standards aim to set basic safety requirements for medical electrical equipment. "With hazardous voltages present in a system a robust and reliable approach to isolation is needed such that multiple and un-related insulation system failures would need to occur before an operator or patient is put at risk.