enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Computer fan control - Wikipedia

   en.wikipedia.org/wiki/Computer_fan_control

   Another method of reducing the fan speed [5] is by moving the 5 V wire in the classical Molex power connector in the place of the Ground wire going to the fan, thereby delivering +7 V (12 V − 5 V = 7 V) to the fan. However, this is a potentially risky method, because +5 V PSU line is intended to source current only, not sink it, so the PSU is ...

3. Fan coil unit - Wikipedia

   en.wikipedia.org/wiki/Fan_coil_unit

   DC motors allow the speed of the fans within a fan coil unit to be controlled by means of a 0-10 Volt input control signal to the motor/s, the transformers and speed switches associated with AC fan coils are not required. Up to a signal voltage of 2.5 Volts (which may vary with different fan/motor manufacturers) the fan will be in a stopped ...

4. Computer fan - Wikipedia

   en.wikipedia.org/wiki/Computer_fan

   A small blower fan is used to direct air across a laptop computer's CPU cooler. A case fan may be mounted on a radiator attached to the case, simultaneously operating to cool a liquid cooling device's working fluid and to ventilate the case. In laptops, a single blower fan often cools a heat sink connected to both CPU and GPU using heat pipes.

5. Switched-mode power supply - Wikipedia

   en.wikipedia.org/wiki/Switched-mode_power_supply

   Stand-alone switched-mode power supply An adjustable switched-mode power supply for laboratory use. A switched-mode power supply (SMPS), also called switching-mode power supply, switch-mode power supply, switched power supply, or simply switcher, is an electronic power supply that incorporates a switching regulator to convert electrical power efficiently.

6. Pulse-width modulation - Wikipedia

   en.wikipedia.org/wiki/Pulse-width_modulation

   Variable-speed computer fan controllers usually use PWM, as it is far more efficient when compared to a potentiometer or rheostat. (Neither of the latter is practical to operate electronically; they would require a small drive motor.) Light dimmers for home use employ a specific type of PWM control.

7. Electrical ballast - Wikipedia

   en.wikipedia.org/wiki/Electrical_ballast

   The ballast is a fixed resistor with usually two center taps, and the fan speed selector switch is used to bypass portions of the ballast: all of them for full speed, and none for the low speed setting. A very common failure occurs when the fan is being constantly run at the next-to-full speed setting (usually 3 out of 4).