Search results
Results from the WOW.Com Content Network
Unlike coil springs, leaf springs also locate the rear axle, eliminating the need for trailing arms and a Panhard rod, thereby saving cost and weight in a simple live axle rear suspension. A further advantage of a leaf spring over a helical spring is that the end of the leaf spring may be guided along a definite path.
The axle receives its vertical and transverse support from a transverse leaf spring (leaf springs were often used for support in more than one direction), and its longitudinal support from fore-aft links sometimes called "radius rods" which are attached (via pivots) to the ends of the axle at their forward end and to the sides of the chassis ...
An equalising system links not only the driving-wheel axles but also the trailing and/or leading truck axle(s). [3]: 32 [5] [6]: 425 Leaf springs Main suspension springs for the locomotive. Each driving wheel supports its share of the locomotive's weight via leaf springs that connect the axle's journal box / axle box (40) to the frame.
This is an especially severe problem when a swing axle is used in a rear-engine design, because of the greater side-g forces on the rear wheels from the mass of the engine. Camber changes during deceleration can increase the severity of lift-off oversteer. 1964 Corvair swing-axle rear suspension with transverse leaf spring
This is an example of a "dead axle". A "live axle" not only connects two wheels, but also drives them. A beam axle, rigid axle, or solid axle is a dependent suspension design in which a set of wheels is connected laterally by a single beam or shaft. Beam axles were once commonly used at the rear wheels of a vehicle, but historically, they have ...
The twist-beam rear suspension (also torsion-beam axle, deformable torsion beam, or compound crank) is a type of automobile suspension based on a large H- or C-shaped member. The front of the H attaches to the body via rubber bushings , and the rear of the H carries each stub-axle assembly, on each side of the car.
The system uses longitudinal leaf springs attached both forward and behind the differential of the live axle. These springs transmit torque to the frame. Although scorned by many European car makers of the time, it was accepted by American car makers, because it was inexpensive to manufacture.
The AC Cobra is an example of a transverse, multi-leaf steel spring suspension that uses the leaf spring as the upper suspension arm. Alternatively, the 1963 Corvette's rear suspension is an example where the transverse leaf spring is used only as a ride spring. In both examples, the leaf spring is centrally mounted, preventing displacement of ...