enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Load dump - Wikipedia

   en.wikipedia.org/wiki/Load_dump

   Load dump means the disconnection of a powered load. It can cause two problems: failure of supply to equipment or customers; large voltage spikes from the inductive generator(s) In automotive electronics, it refers to the disconnection of the vehicle battery from the alternator while the battery is being charged. Due to such a disconnection of ...

3. Load testing - Wikipedia

   en.wikipedia.org/wiki/Load_testing

   A load test can be used to evaluate the health of a car's battery.The tester consists of a large resistor that has a resistance similar to a car's starter motor and a meter to read the battery's output voltage both in the unloaded and loaded state.

4. Battery tester - Wikipedia

   en.wikipedia.org/wiki/Battery_tester

   Battery tester. A battery tester is an electronic device intended for testing the state of an electric battery, going from a simple device for testing the charge actually present in the cells and/or its voltage output, to a more comprehensive testing of the battery's condition, namely its capacity for accumulating charge and any possible flaws affecting the battery's performance and security.

5. ELM327 - Wikipedia

   en.wikipedia.org/wiki/ELM327

   The ELM327 is a programmed microcontroller produced for translating the on-board diagnostics (OBD) interface found in most modern cars. The ELM327 command protocol is one of the most popular PC-to-OBD interface standards and is also implemented by other vendors.

6. Dummy load - Wikipedia

   en.wikipedia.org/wiki/Dummy_load

   A dummy load is a device used to simulate an electrical load, usually for testing purposes. In radio a dummy antenna is connected to the output of a radio transmitter and electrically simulates an antenna , to allow the transmitter to be adjusted and tested without radiating radio waves .

7. Load bank - Wikipedia

   en.wikipedia.org/wiki/Load_bank

   A load bank is a piece of electrical test equipment used to simulate an electrical load, to test an electric power source without connecting it to its normal operating load. [ 1 ] [ 2 ] During testing, adjustment, calibration, or verification procedures, a load bank is connected to the output of a power source, such as an electric generator ...