Search results
Results from the WOW.Com Content Network
Link-local addresses are typically assigned automatically through a process known as link-local address autoconfiguration, [1] also known as auto-IP, automatic private IP addressing (APIPA, specific to IPv4), and stateless address autoconfiguration (SLAAC, specific to IPv6).
IPv6 addresses are assigned to organizations in much larger blocks as compared to IPv4 address assignments—the recommended allocation is a / 48 block which contains 2 80 addresses, being 2 48 or about 2.8 × 10 14 times larger than the entire IPv4 address space of 2 32 addresses and about 7.2 × 10 16 times larger than the / 8 blocks of IPv4 ...
Once a unique link-local address is established, the IPv6 host determines whether the LAN is connected on this link to any router interface that supports IPv6. It does so by sending out an ICMPv6 router solicitation message to the all-routers [44] multicast group with its link-local address as source. If there is no answer after a predetermined ...
A unique local address (ULA) is an Internet Protocol version 6 (IPv6) address in the address range fc00:: / 7. [1] These addresses are non-globally reachable [ 2 ] (routable only within the scope of private networks, but not the global IPv6 Internet).
Used for loopback addresses to the local host [1] 169.254.0.0/16 169.254.0.0–169.254.255.255 65 536: Subnet Used for link-local addresses [5] between two hosts on a single link when no IP address is otherwise specified, such as would have normally been retrieved from a DHCP server 172.16.0.0/12 172.16.0.0–172.31.255.255 1 048 576: Private ...
A solicited-node multicast address is an IPv6 multicast address used by the Neighbor Discovery Protocol to determine the link layer address associated with a given IPv6 address, which is also used to check if an address is already being used by the local-link or not, through a process called DAD (Duplicate Address Detection). The solicited-node ...
The Dynamic Host Configuration Protocol version 6 (DHCPv6) is a network protocol for configuring Internet Protocol version 6 (IPv6) hosts with IP addresses, IP prefixes, default route, local segment MTU, and other configuration data required to operate in an IPv6 network.
IPv6 hosts are required to support multiple addresses per interface; moreover, every IPv6 host is required to configure a link-local address even when global addresses are available. IPv6 hosts may additionally self-configure additional addresses on receipt of router advertisement messages, thus eliminating the need for a DHCP server. [2]