Search results
Results from the WOW.Com Content Network
Schematic water brake on a dynamometer A 4-minute ‘how-it-works video’ tutorial explaining how engine-dynamometer water-brake absorbers work. A water brake is a type of fluid coupling used to absorb mechanical energy and usually consists of a turbine or propeller mounted in an enclosure filled with water. As the turbine or propeller turns ...
An air cycle machine (ACM) is the refrigeration unit of the environmental control system (ECS) used in pressurized gas turbine-powered aircraft. Normally an aircraft has two or three of these ACM. Each ACM and its components are often referred as an air conditioning pack.
HVAC (Heating, Ventilation and Air Conditioning) equipment needs a control system to regulate the operation of a heating and/or air conditioning system. [1] Usually a sensing device is used to compare the actual state (e.g. temperature) with a target state. Then the control system draws a conclusion what action has to be taken (e.g. start the ...
The equipment used can consist of machines used to remove heat such as a chiller or a cooling tower and equipment for adding heat to the building's water such as a boiler or a commercial water heater. Hydronic fan coil units can be generally divided into two types: Two-pipe fan coil units or four-pipe fan coil units. Two-pipe fan coil units ...
Based upon the size of the clutch or brake, the speed and the inertia, wear rates will differ. For example, a machine that was running at 500 rpm with a clutch and is now sped up to 1000 rpm would have its wear rate significantly increased because the amount of energy required to start the same amount of inertia is a lot higher at the higher speed.
Disk electromagnetic brakes are used on vehicles such as trains, and power tools such as circular saws, to stop the blade quickly when the power is turned off.A disk eddy current brake consists of a conductive non-ferromagnetic metal disc attached to the axle of the vehicle's wheel, with an electromagnet located with its poles on each side of the disk, so the magnetic field passes through the ...
Principal view of the pumping action of a twin-screw pump with a six-lobe female screw and a five-lobe male screw. A compressor (as opposed to a pump) would be shaped the same way, except that the shape of the lobes would change along the length of the screw, so that the volume of the trapped pockets would get squeezed smaller as they get closer to the exhaust port.
Friction brakes eventually wear out with use and require replacement of braking components. DC brake modules do not have consumable parts and should not require maintenance. Friction brakes also require a method of actuation, requiring either a human operator or system controlled actuator, adding to the complexity of the system.