enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Reference designator - Wikipedia

    en.wikipedia.org/wiki/Reference_designator

    The reference designator usually consists of one or two letters followed by a number, e.g. C3, D1, R4, U15. The number is sometimes followed by a letter, indicating that components are grouped or matched with each other, e.g. R17A, R17B. The IEEE 315 standard contains a list of Class Designation Letters to use for electrical and electronic ...

  3. List of valves - Wikipedia

    en.wikipedia.org/wiki/List_of_valves

    Used in oil and gas wellheads, where the pressure drop is high. (Not to be confused with engine choke valve, below.) Diaphragm valve or membrane valve, controls flow by movement of a diaphragm. Used in pharmaceutical applications; Gate valve, mainly for on–off control, with low pressure drop; Globe valve, good for regulating flow. Uses a ...

  4. Piping and instrumentation diagram - Wikipedia

    en.wikipedia.org/wiki/Piping_and_instrumentation...

    Pressure reducing valve: Valve: Gate valve: Control valve: Manual valve Check valve: Needle valve: Butterfly valve: Diaphragm valve: Ball valve: Check valve: Back draft damper Bag Gas bottle: Globe valve: 3-way valve Piston or reciprocating compressor: Relief valve: Rupture disc: Turboexpander: Centrifugal pump: Reciprocating pump

  5. Oil pressure - Wikipedia

    en.wikipedia.org/wiki/Oil_pressure

    Murphy oil pressure gauges with switches that activate on low pressure. Oil pressure is an important factor in the longevity of most internal combustion engines. [1] With a forced lubrication system (invented by Frederick Lanchester), oil is picked up by a positive displacement oil pump and forced through oil galleries (passageways) into bearings, such as the main bearings, big end bearings ...

  6. Pressure regulator - Wikipedia

    en.wikipedia.org/wiki/Pressure_regulator

    Diagram symbols for pressure reduction and back pressure regulators. The conceptual difference is mainly in which side the feedback is taken from. A pressure regulator is a valve that controls the pressure of a fluid to a desired value, using negative feedback from the controlled pressure. Regulators are used for gases and liquids, and can be ...

  7. Oil pump (internal combustion engine) - Wikipedia

    en.wikipedia.org/wiki/Oil_pump_(internal...

    Indications of low oil pressure may be that the warning light is on, a low pressure reading on the gauge, or clattering/clinking noises from the engine. Low oil pressure is a problem that must be addressed immediately to prevent serious damage. The leading cause of low oil pressure in an engine is wear on the engine's vital parts.

  8. Centrifugal governor - Wikipedia

    en.wikipedia.org/wiki/Centrifugal_governor

    The balls swing out as speed increases, which closes the valve, until a balance is achieved between demand and the proportional gain of the linkage and valve. A centrifugal governor is a specific type of governor with a feedback system that controls the speed of an engine by regulating the flow of fuel or working fluid , so as to maintain a ...

  9. Engine configuration - Wikipedia

    en.wikipedia.org/wiki/Engine_configuration

    1919 Napier Lion II aircraft engine with three cylinder banks. Any design of motor/engine,be it a V or a boxer can be called an "in-line" if it's mounted in-line with the frame/chassis and in-line with the direction of travel of the vehicle.When the motor/engine is across the frame/chassis this is called a TRANSVERSE motor.Cylinder arrangement is not in the description of how the motor/engine ...