Search results
Results from the WOW.Com Content Network
The largest P1 can print objects up to 16m x 9m x 2.5m. [34] Total Custom concrete 3D printer developed by Rudenko is a concrete deposition technology mounted in a gantry configuration, the system has a similar output to Winsun and other concrete 3D printing technologies, however it uses a lightweight truss type gantry. [35]
A print head that is set too high will reduce the bond strength between layers, causing an unstable shape. [8] A nozzle too close to the printing surface may interfere with the printing process and place additional loads on the concrete. Research proposes a print height equal to the width of the nozzle. [8]
Piping and instrumentation diagram of pump with storage tank. Symbols according to EN ISO 10628 and EN 62424. A more complex example of a P&ID. A piping and instrumentation diagram (P&ID) is defined as follows: A diagram which shows the interconnection of process equipment and the instrumentation used to control the process.
A thermal expansion valve is a key element to a heat pump; this is the cycle that makes air conditioning, or air cooling, possible.A basic refrigeration cycle consists of four major elements: a compressor, a condenser, a metering device and an evaporator.
An air-cooled condenser is however, significantly more expensive and cannot achieve as low a steam turbine exhaust pressure (and temperature) as a water-cooled surface condenser. Surface condensers are also used in applications and industries other than the condensing of steam turbine exhaust in power plants.
To replace IEEE 200-1975, ASME, a standards body for mechanical engineers, initiated the new standard ASME Y14.44-2008. This standard, along with IEEE 315-1975, provide the electrical designer with guidance on how to properly reference and annotate everything from a single circuit board to a collection of complete enclosures.
Pad-mount transformers are usually located on the street easements and supply multiple households in residential areas. While most traditional pad-mount transformers are fixed on a concrete 'pad,' today, small single-phase designs are also available with the transformer already mounted on a 'polypad' base to be mounted on hard ground, connected ...
It is called an "over-under" configuration with the drywell forming a truncated cone on a concrete slab. Below is a cylindrical suppression chamber made of concrete rather than just sheet metal. Both use a lightweight steel or concrete "secondary containment" over the top floor which is kept at a slight negative pressure so that air can be ...