Search results
Results from the WOW.Com Content Network
Their wires were led through holes to the underside or interior. The ends of lengths of wire or wire-ended components such as capacitors and resistors were pushed through the terminals, and usually looped and twisted. When all wires to be connected had been fitted to the terminal, they were soldered together (and to the terminal).
A blade connector is a type of single wire, plug-and-socket connection device using a flat conductive blade (plug) that is inserted into a receptacle. Wires are typically attached to male or female blade connector terminals by either crimping or soldering. Insulated and uninsulated varieties are available.
Terminal symbol A terminal strip, to which wires can be soldered. A terminal is the point at which a conductor from a component, device or network comes to an end. [1] Terminal may also refer to an electrical connector at this endpoint, acting as the reusable interface to a conductor and creating a point where external circuits can be connected.
The top-most layers of a chip have the thickest and widest and most widely separated metal layers, which make the wires on those layers have the least resistance and smallest RC time constant, so they are used for power and clock distribution networks. The bottom-most metal layers of the chip, closest to the transistors, have thin, narrow ...
A rat-tail splice, also known as a twist splice or a pig-tail splice, is a basic electrical splice that can be done with both solid and stranded wire. It is made by taking two or more bare wires and wrapping them together symmetrically around the common axis of both wires. The bare splice can be insulated with electrical tape or by other means.
In electronic design, wire routing, commonly called simply routing, is a step in the design of printed circuit boards (PCBs) and integrated circuits (ICs). It builds on a preceding step, called placement , which determines the location of each active element of an IC or component on a PCB.
Printed circuit board (PCB) terminal blocks are specially designed with a copper alloy pin of suitable size and length, and can be inserted into printed circuit boards for soldering in place. Some designs provide features that allow the flow of molten solder to ensure a better connection between the circuit traces of the board and the ...
Mechanical wire wrap tool Electrical wire wrap tool; pneumatic (air-powered) tools are also available. A "wire wrap tool" has two holes. The wire and 1 ⁄ 4 in (6.4 mm) of insulated wire are placed in a hole near the edge of the tool. The hole in the center of the tool is placed over the post.