Search results
Results from the WOW.Com Content Network
TCP/IP defines the addresses 192.168.4.0 (network ID address) and 192.168.4.255 (broadcast IP address). The office's hosts send packets to addresses within this range directly, by resolving the destination IP address into a MAC address with the Address Resolution Protocol (ARP) sequence and then encapsulates the IP packet into a MAC frame ...
The access router gives the dial-up nodes IP addresses in the range 192.168.0.128 – 192.168.0.254; for this example, assume a dial-up node gets IP address 192.168.0.254. The access router uses proxy ARP to make the dial-up node present in the subnet without being wired into the Ethernet: the access router 'publishes' its own MAC address for ...
A network and wildcard mask combination of 1.1.1.1 0.0.0.0 would match an interface configured exactly with 1.1.1.1 only, and nothing else. Wildcard masks are used in situations where subnet masks may not apply. For example, when two affected hosts fall in different subnets, the use of a wildcard mask will group them together.
YIADDR (Your IP address: 0xC0A80164 or 192.168.1.100) 48 384 SIADDR (Server IP address: 0xC0A80101 or 192.168.1.1) 52 416 GIADDR (Gateway IP address: 0x00000000) 56 448 CHADDR (Client Hardware address: 0x00053C04 0x8D590000 0x00000000 0x00000000) 60 480 64 512 68 544 72 576 192 octets of 0s, or overflow space for additional options; BOOTP ...
Address of the server: 192.168.1.2; Address of a local computer: 192.168.1.100; If a packet is sent to 203.0.113.1 by a computer at 192.168.1.100, the packet would normally be routed to the default gateway (the router) [e] A router with the NAT loopback feature detects that 203.0.113.1 is the address of its WAN interface, and treats the packet ...
In Internet networking, a private network is a computer network that uses a private address space of IP addresses.These addresses are commonly used for local area networks (LANs) in residential, office, and enterprise environments.
In this example, gateway 192.168.0.1 (the internet router) can be reached through the local network card with address 192.168.0.100. Finally, the Metric indicates the associated cost of using the indicated route. This is useful for determining the efficiency of a certain route from two points in a network.
NOTE: a RID is the highest logical (loopback) IP address configured on a router, if no logical/loopback IP address is set then the router uses the highest IP address configured on its active interfaces (e.g. 192.168.0.1 would be higher than 10.1.1.2). Usually the router with the second-highest priority number becomes the BDR.