Search results
Results from the WOW.Com Content Network
The concentration of solvent in water ranges from 40 to 80%. Higher boiling solvents have the advantage of a lower process pressure. This is weighed against the more difficult solvent recovery by distillation. [2] Ethanol has been suggested as the preferred solvent due to cost and easy recovery.
The method of extractive distillation uses a separation solvent, which is generally non-volatile, has a high boiling point and is miscible with the mixture, but doesn't form an azeotropic mixture. The solvent interacts differently with the components of the mixture thereby causing their relative volatilities to change.
Short-path distillation is a distillation technique that involves the distillate traveling a short distance, often only a few centimeters, and is normally done at reduced pressure. [ 1 ] [ 2 ] Short-path distillation systems often have a variety of names depending on the manufacturer of the system and what compounds are being distilled within them.
Leaching can occur naturally seen from plant substances (inorganic and organic), [2] [3] solute leaching in soil, [4] and in the decomposition of organic materials. [5] Leaching can also be applied affectedly to enhance water quality and contaminant removal, [ 1 ] [ 6 ] as well as for disposal of hazardous waste products such as fly ash , [ 7 ...
A separatory funnel used for liquid–liquid extraction, as evident by the two immiscible liquids.. Liquid–liquid extraction, also known as solvent extraction and partitioning, is a method to separate compounds or metal complexes, based on their relative solubilities in two different immiscible liquids, usually water (polar) and an organic solvent (non-polar).
For example, volatile oils can be extracted from a plant with low pressures (100 bar), whereas liquid extraction would also remove lipids. Lipids can be removed using pure CO 2 at higher pressures, and then phospholipids can be removed by adding ethanol to the solvent. [ 1 ]
Deep soil mixing requires specialized auger mixing equipment. In order to apply this method in-situ and in deep soil, the oxidant must be pumped to the point of mixing using a kelly bar (a piece of earth drilling equipment), or appropriate piping to the place where the soil needs to be oxidized. The soil then has to be mixed by using mixing blades.
A typical solid phase extraction involves five basic steps. First, the cartridge is equilibrated with a non-polar or slightly polar solvent, which wets the surface and penetrates the bonded phase. Then water, or buffer of the same composition as the sample, is typically washed through the column to wet the silica surface.