Search results
Results from the WOW.Com Content Network
An IEEE 1284 36-pin male micro ribbon printer cable connection. The computer side normally uses a DB-25 port instead of this connector. IEEE 1284, also known as the Centronics port, is a standard that defines bi-directional parallel communications between computers and other devices.
This size, with 36 pins and bail locks, is also known as a Centronics connector because of its introduction by Centronics for use with the parallel port of printers, and is standardized as IEEE 1284 type B. Other connectors of this size are also called Centronics connectors. The smaller size has 0.050 inch (1.27 mm) pitch.
When IBM implemented the parallel interface on the IBM PC, they used the DB-25F connector at the PC-end of the interface, creating the now familiar parallel cable with a DB25M at one end and a 36-pin micro ribbon connector at the other. In theory, the Centronics port could transfer data as rapidly as 75,000 characters per second.
IEEE 200-1975 or "Standard Reference Designations for Electrical and Electronics Parts and Equipments" is a standard that was used to define referencing naming systems for collections of electronic equipment. IEEE 200 was ratified in 1975. The IEEE renewed the standard in the 1990s, but withdrew it from active support shortly thereafter.
eSATAp cables are available with wide connectors to plug directly into the power and signal connectors of a bare drive, providing a 12 V supply in the case of a desktop machine. A version of this wide connector is found inside every external SATA hard drive enclosure; when the hard drive is slid inside, it mates with a connector that supplies ...
However, parallel lines have lower latency than serial lines, this makes parallel lines is still used on memory bus like DDR SDRAM. Cable length or link length: Crosstalk creates interference between the parallel lines, and the effect worsens with the length of the communication link. This places an upper limit on the length of a parallel data ...
In some cases, though, the host adapter end of the cable would use a different connector. For example, in the Sun 260 series chassis (used for the Sun 3/260 and Sun 4/260 computers), the connector was the same 3-row 96-pin connector used to attach peripheral cards to the VMEbus backplane .
The PIA is designed for glueless connection to the Motorola 6800 style bus, and provides 20 I/O lines, which are organised into two 8-bit bidirectional ports (or 16 general-purpose I/O lines) and 4 control lines (for handshaking and interrupt generation). The directions for all 16 general lines (PA0-7, PB0-7) can be programmed independently.