enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. ASTM F568M - Wikipedia

   en.wikipedia.org/wiki/ASTM_F568M

   This standard defines property classes, the metric equivalent of a screw grade, that are almost identical to those defined by ISO 898-1, [2] except for the addition of the 8.8.3 and 10.9.3 classes. These two additional standards are fasteners that have the same mechanical properties as their base property class (i.e. 8.8 and 10.9), but are made ...

3. ASTM A490 - Wikipedia

   en.wikipedia.org/wiki/ASTM_A490

   ASTM A490 and ASTM A490M are ASTM International standards for heavy hex structural bolts made from alloy steel.The imperial standard is officially titled Standard Specification for Structural Bolts, Alloy Steel, Heat Treated, 150 ksi Minimum Tensile Strength, while the metric standard (M) is titled Standard Specification for High-Strength Steel Bolts, Classes 10.9 and 10.9.3, for Structural ...

4. Screw - Wikipedia

   en.wikipedia.org/wiki/Screw

   High-strength steel bolts usually have a hexagonal head with an ISO strength rating (called property class) stamped on the head. And the absence of marking/number indicates a lower grade bolt with low strength. The property classes most often used are 5.8, 8.8, and 10.9. The number before the point is the ultimate tensile strength in MPa ...

5. ISO 898 - Wikipedia

   en.wikipedia.org/wiki/ISO_898

   This standard is the origin for other standards that define properties for similar metric fasteners, such as SAE J1199 and ASTM F568M. [1] It is divided into five (nonconsecutive) parts: 1. Bolts, screws and studs with specified property classes – Coarse thread and fine pitch thread [2] 2. Nuts with specified proof load values – Coarse ...

6. ASTM A325 - Wikipedia

   en.wikipedia.org/wiki/ASTM_A325

   ASTM A325 is an ASTM International standard for heavy hex structural bolts, titled Standard Specification for Structural Bolts, Steel, Heat Treated, 120/105 ksi Minimum Tensile Strength. It defines mechanical properties for bolts that range from 1 ⁄ 2 to 1 + 1 ⁄ 2 inches (13 to 38 mm) in diameter. [1]

7. Bolt (fastener) - Wikipedia

   en.wikipedia.org/wiki/Bolt_(fastener)

   Bolted joint in vertical section Screw joint. The distinction between a bolt and a screw is poorly defined. The academic distinction, per Machinery's Handbook, [3] is in their intended purpose: bolts are designed to pass through an unthreaded hole in a component and be fastened with the aid of a nut.