Search results
Results from the WOW.Com Content Network
in a removable discontinuity, the distance that the value of the function is off by is the oscillation; in a jump discontinuity, the size of the jump is the oscillation (assuming that the value at the point lies between these limits of the two sides); in an essential discontinuity, oscillation measures the failure of a limit to exist.
A discontinuity may exist as a single feature (e.g. fault, isolated joint or fracture) and in some circumstances, a discontinuity is treated as a single discontinuity although it belongs to a discontinuity set, in particular if the spacing is very wide compared to the size of the engineering application or to the size of the geotechnical unit.
This page was last edited on 10 January 2015, at 10:07 (UTC).; Text is available under the Creative Commons Attribution-ShareAlike License 4.0; additional terms may apply.
Grouted tiebacks can be constructed as steel rods drilled through a concrete wall out into the soil or bedrock on the other side. Grout is then pumped under pressure into the tieback anchor holes to increase soil resistance and thereby prevent tiebacks from pulling out, reducing the risk for wall destabilization.
The diaphragm of a structure often does double duty as the floor system or roof system in a building, or the deck of a bridge, which simultaneously supports gravity loads. [1] Parts of a diaphragm include: [2] the collector (or membrane), used as a shear panel to carry in-plane shear
A non-persistent discontinuity ends in intact soil or rock. Before movement of the material on both sides of a non-persistent discontinuity is possible, the discontinuity has to extend and break through intact material. As intact material has virtually always far higher shear strength than the discontinuity, a non-persistent discontinuity will ...
WASHINGTON (Reuters) -U.S. manufacturing contracted at a moderate pace in November, with orders growing for the first time in eight months and factories facing significantly lower prices for inputs.
In building construction, weeps are typically found in a masonry veneer or cavity wall, just above the flashing. The cavity serves as a way to drain this water back out through the weep holes. The weep holes allow wind to create an air stream through the cavity. The stream removes evaporated water from the cavity to the outside.