Search results
Results from the WOW.Com Content Network
30-pin SIMM, 256 KB capacity Two 30-pin SIMM slots on an IBM PS/2 Model 50 motherboard. Standard sizes: 256 KB, 1 MB, 4 MB, 16 MB. 30-pin SIMMs have 12 address lines, which can provide a total of 24 address bits. With an 8-bit data width, this leads to an absolute maximum capacity of 16 MB for both parity and non-parity modules (the additional redundancy-bit chip usually doe
As with parity RAM, additional information needs to be stored and more processing needs to be done, making ECC RAM more expensive and a little slower than non-parity and logic parity RAM. This type of ECC memory is especially useful for any application where reliability or uptime is a concern: failing bits in a memory word are detected and ...
In computing, serial presence detect (SPD) is a standardized way to automatically access information about a memory module. Earlier 72-pin SIMMs included five pins that provided five bits of parallel presence detect (PPD) data, but the 168-pin DIMM standard changed to a serial presence detect to encode more information.
Maximum memory is therefore 52 MB for two-slot systems, and 36 MB for one-slot systems. [ 5 ] Hard drive controller : One of the big differences, when compared to some of the previous Macintosh models was the choice of the internal hard drive interface; conforming to the standards of the IBM PC compatible platform, cheaper but slower IDE drives ...
A modern PC with a bus rate of around 1 GHz and a 32-bit bus might be 2000x or even 5000x faster, but might have many more gigabytes of memory. With boot times more of a concern now than in the 1980s, the 30- to 60-second memory test adds undesirable delay for a benefit of confidence that is not perceived to be worth that cost by most users.
Memory geometry describes the logical configuration of a RAM module, but consumers will always find it easiest to grasp the physical configuration. Much of the confusion surrounding memory geometry occurs when the physical configuration obfuscates the logical configuration. The first defining feature of RAM is form factor.
The RAM slots and the PCI slots are parallel to each other. Processor is placed closest to the fan. May contain a CNR board. MicroBTX (or uBTX) Intel 2004 264 × 267 mm max (10.4 × 10.5 in) MicroBTX (also called uBTX) is a computer motherboard form factor. A microBTX is 10.4 × 10.5 in (264 × 267 mm) and can support up to four expansion slots ...
Dual-ported RAM (DPRAM), also called dual-port RAM, is a type of random-access memory (RAM) that can be accessed via two different buses.. A simple dual-port RAM may allow only read access through one of the ports and write access through the other, in which case the same memory location cannot be accessed simultaneously through the ports since a write operation modifies the data and therefore ...