Search results
Results from the WOW.Com Content Network
In computing, serial presence detect (SPD) is a standardized way to automatically access information about a memory module. Earlier 72-pin SIMMs included five pins that provided five bits of parallel presence detect (PPD) data, but the 168-pin DIMM standard changed to a serial presence detect to encode more information.
30-pin SIMM, 256 KB capacity Two 30-pin SIMM slots on an IBM PS/2 Model 50 motherboard. Standard sizes: 256 KB, 1 MB, 4 MB, 16 MB. 30-pin SIMMs have 12 address lines, which can provide a total of 24 address bits. With an 8-bit data width, this leads to an absolute maximum capacity of 16 MB for both parity and non-parity modules (the additional redundancy-bit chip usually doe
In computing, a memory module or RAM stick is a printed circuit board on which memory integrated circuits are mounted. [1] Memory modules permit easy installation and replacement in electronic systems, especially computers such as personal computers, workstations, and servers. The first memory modules were proprietary designs that were specific ...
Also, each module has eight RAM chips, but the lower one has an unoccupied space for the ninth chip; this space is occupied in ECC DIMMs. Three SDRAM DIMM slots on a ABIT BP6 computer motherboard. A DIMM ( Dual In-Line Memory Module ) is a popular type of memory module used in computers.
Those modules are identified by an additional R in their designation, whereas non-registered (a.k.a. "unbuffered") RAM may be identified by an additional U in the designation. PC2-4200R is a registered PC2-4200 module, PC2-4200R ECC is the same module but with additional ECC.
In a computer, the memory bank may be determined by the memory controller along with physical organization of the hardware memory slots. In a typical synchronous dynamic random-access memory (SDRAM) or double data rate SDRAM (DDR SDRAM), a bank consists of multiple rows and columns of storage units, and is usually spread out across several chips .
Double data rate (DDR) memory controllers are used to drive DDR SDRAM, where data is transferred on both rising and falling edges of the system's memory clock.DDR memory controllers are significantly more complicated when compared to single data rate controllers, [citation needed] but they allow for twice the data to be transferred without increasing the memory's clock rate or bus width.
ECC support varies among motherboard manufacturers, so ECC memory may simply not be recognized by an ECC-incompatible motherboard. Most motherboards and processors for less critical applications are not designed to support ECC. Some ECC-enabled boards and processors are able to support unbuffered (unregistered) ECC, but will also work with non ...