enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Bicycle brake - Wikipedia

   en.wikipedia.org/wiki/Bicycle_brake

   Bicycle drum brakes operate like those of a car, although the bicycle variety use cable rather than hydraulic actuation. Two pads are pressed outward against the braking surface on the inside of the hub shell. Shell inside diameters on a bicycle drum brake are typically 70–120 mm (2.756–4.724 in).

3. Brake pad - Wikipedia

   en.wikipedia.org/wiki/Brake_pad

   The concept of brake pads or disc brakes as an alternative to drum brakes had been around at least as early as a patent by F. W. Lanchester in 1902. [2] However, due to high cost and inefficiencies compared to drum brakes they were not commonly implemented until after World War II. [3]

4. SureStop - Wikipedia

   en.wikipedia.org/wiki/SureStop

   Once the brake pads make contact with the rear wheel, the Slidepad slides forward, which pulls a cable that is connected to the front brakes. [1] Similar to the anti-lock brake system in cars, the mechanism prevents the front wheel from locking, no matter how hard the brake is pressed or how slippery the road conditions are.

5. List of bicycle parts - Wikipedia

   en.wikipedia.org/wiki/List_of_bicycle_parts

   Brake: devices used to stop or slow down a bicycle. Rim brakes and disc brakes are operated by brake levers, which are mounted on the handlebars. Band brake is an alternative to rim brakes but can only be installed at the rear wheel. Coaster brakes are operated by pedaling backward; Brake lever: a lever for actuating a bicycle brake

6. Disc brake - Wikipedia

   en.wikipedia.org/wiki/Disc_brake

   On automobiles, disc brakes are often located within the wheel A drilled motorcycle brake disc. The development of disc-type brakes began in England in the 1890s. In 1902, the Lanchester Motor Company designed brakes that looked and operated similarly to a modern disc-brake system even though the disc was thin and a cable activated the brake pad. [4]

7. Brake lining - Wikipedia

   en.wikipedia.org/wiki/Brake_lining

   The brake lining is that part of the brake pad which actually contacts the metal brake disc (rotor) when the brake is engaged. Using a typical bicycle brake as an example, the backing would be the metal shell which provides mechanical support, and the lining would be the rubbery portion which contacts the rims when the brakes are applied.