enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Spin casting - Wikipedia

   en.wikipedia.org/wiki/Spin_casting

   The spin casting process typically uses vulcanized silicone or organic rubber as the mold-making substrate. Vulcanization is an integral step that occurs halfway through the mold-making process. Prior to vulcanization, the mold rubber is a soft and malleable solid-like fluid, in many ways very similar to Silly Putty. Because of the clay-like ...

3. Resin casting - Wikipedia

   en.wikipedia.org/wiki/Resin_casting

   The creation of a toy or figure start with the traditional sculpting process where the artist designs a clay sculpture. Where appropriate, for example when making a garage kit, the sculpture is dissected into several parts like head, torso, arms and legs. A flexible mold made from room temperature vulcanized (RTV) silicone rubber is made for ...

4. Compression molding - Wikipedia

   en.wikipedia.org/wiki/Compression_molding

   Compression molding is a method of molding in which the molding material, generally preheated, is first placed in an open, heated mold cavity. The mold is closed with a top force or plug member, pressure is applied to force the material into contact with all mold areas, while heat and pressure are maintained until the molding material has cured; this process is known as compression molding ...

5. Vacuum casting (elastomers) - Wikipedia

   en.wikipedia.org/wiki/Vacuum_casting_(elastomers)

   The process starts by placing a two piece silicone mold in a vacuum chamber. The raw material is mixed, degassed and then poured into the mold. The vacuum is then released and the mold removed from the chamber. Finally, the casting is cured in an oven and the mold removed to release the completed casting. The silicone mold can be reused. [3]

6. Release agent - Wikipedia

   en.wikipedia.org/wiki/Release_agent

   The silicone keeps the rubber from sticking to the mold but just as important it lubricates the rubber so it will slide over the hot mold as it is loaded. Diluted silicone typically has to be applied every cycle. Semi-permanent mold release builds a silicone matrix on the mold that becomes a barrier between the rubber and the metal surface of ...

7. How to Make a Jell-O Mold That Comes Out Perfect

   www.aol.com/jell-o-mold-comes-perfect-150003594.html

   Use hot water to remove a stubborn Jell-O mold: If your mold isn’t releasing from the pan, set the mold in a pan of hot water for 10 seconds and try to remove it again. Repeat the process until ...