enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Spin casting - Wikipedia

   en.wikipedia.org/wiki/Spin_casting

   The spin casting process typically uses vulcanized silicone or organic rubber as the mold-making substrate. Vulcanization is an integral step that occurs halfway through the mold-making process. Prior to vulcanization, the mold rubber is a soft and malleable solid-like fluid, in many ways very similar to Silly Putty. Because of the clay-like ...

3. Polymer clay - Wikipedia

   en.wikipedia.org/wiki/Polymer_clay

   Once conditioned, the clay will remain pliable until the particles eventually re-adhere. [8] Oven-hardenable PVC plastisol, "liquid polymer clay," is a complement to polymer clay that can be used as an adhesive to combine pieces, or to create various effects. Pigments, chalk pastel, and regular polymer clay can be added to make colored liquid clay.

4. Injection molding of liquid silicone rubber - Wikipedia

   en.wikipedia.org/wiki/Injection_molding_of...

   Injection molding of liquid silicone rubber (LSR) is a process to produce pliable, durable parts in high volume.. Liquid silicone rubber is a high purity platinum cured silicone with low compression set, good stability and ability to resist extreme temperatures of heat and cold ideally suitable for production of parts, where high quality is required.

5. Compression molding - Wikipedia

   en.wikipedia.org/wiki/Compression_molding

   Compression molding is a method of molding in which the molding material, generally preheated, is first placed in an open, heated mold cavity. The mold is closed with a top force or plug member, pressure is applied to force the material into contact with all mold areas, while heat and pressure are maintained until the molding material has cured; this process is known as compression molding ...

6. Silicone - Wikipedia

   en.wikipedia.org/wiki/Silicone

   Two-part silicone systems are used as rubber molds to cast resins, foams, rubber, and low-temperature alloys. A silicone mold generally requires little or no mold-release or surface preparation, as most materials do not adhere to silicone. For experimental uses, ordinary one-part silicone can be used to make molds or to mold into shapes.

7. How to Make a Jell-O Mold That Comes Out Perfect

   www.aol.com/jell-o-mold-comes-perfect-150003594.html

   Use hot water to remove a stubborn Jell-O mold: If your mold isn’t releasing from the pan, set the mold in a pan of hot water for 10 seconds and try to remove it again. Repeat the process until ...