Search results
Results from the WOW.Com Content Network
I 0 is the reference sound intensity; 1 Np = 1 is the neper; 1 B = 1 / 2 ln(10) is the bel; 1 dB = 1 / 20 ln(10) is the decibel. The commonly used reference sound intensity in air is [5] = /. being approximately the lowest sound intensity hearable by an undamaged human ear under room conditions.
The decibel originates from methods used to quantify signal loss in telegraph and telephone circuits. Until the mid-1920s, the unit for loss was miles of standard cable (MSC). 1 MSC corresponded to the loss of power over one mile (approximately 1.6 km) of standard telephone cable at a frequency of 5000 radians per second (795.8 Hz), and matched closely the smallest attenuation detectable to a ...
1 dB = 1 / 20 ln 10 is the decibel. The commonly used reference sound power in air is [11] = . The proper notations for sound power level using this reference are L W/(1 pW) or L W (re 1 pW), but the suffix notations dB SWL, dB(SWL), dBSWL, or dB SWL are very common, even if they are not accepted by the SI. [12]
In other media, such as underwater, a reference level of 1 μPa is used. [9] These references are defined in ANSI S1.1-2013. [10] The main instrument for measuring sound levels in the environment is the sound level meter. Most sound level meters provide readings in A, C, and Z-weighted decibels and must meet international standards such as IEC ...
Signal-to-noise ratio (SNR or S/N) is a measure used in science and engineering that compares the level of a desired signal to the level of background noise. SNR is defined as the ratio of signal power to noise power, often expressed in decibels. A ratio higher than 1:1 (greater than 0 dB) indicates more signal than noise.
The sound energy density level gives the ratio of a sound incidence as a sound energy value in comparison to the reference level of 1 pPa (= 10 −12 pascals). [2] It is a logarithmic measure of the ratio of two sound energy densities. The unit of the sound energy density level is the decibel (dB), a non-SI unit accepted for use with the SI ...
A sound with a loudness of 1 sone is judged equally loud as a 1 kHz tone with a sound pressure level of 40 decibels above 20 micropascals. [1] The phon is psychophysically matched to a reference frequency of 1 kHz. [2] In other words, the phon matches the sound pressure level in decibels of a similarly perceived 1 kHz pure tone. [3]
A noise dosimeter (American) or noise dosemeter (British) is a specialized sound level meter intended specifically to measure the noise exposure of a person integrated over a period of time; usually to comply with Health and Safety regulations such as the Occupational Safety and Health (OSHA) 29 CFR 1910.95 Occupational Noise Exposure Standard ...