Search results
Results from the WOW.Com Content Network
TVS diode as array. A transient-voltage-suppression diode may be either unidirectional or bidirectional. A unidirectional device operates as a rectifier in the forward direction like any other avalanche diode, but is made and tested to handle very large peak currents.
Surge Protection Device (SPD) for installation in a low-voltage distribution board. A surge protector (or spike suppressor, surge suppressor, surge diverter, [1] surge protection device (SPD), transient voltage suppressor (TVS) or transient voltage surge suppressor (TVSS)) is an appliance or device intended to protect electrical devices in alternating current (AC) circuits from voltage spikes ...
Diode, rectifier, diode bridge; Schottky diode (hot carrier diode) – super fast diode with lower forward voltage drop; Zener diode – allows current to flow "backwards" when a specific set voltage is reached. Transient voltage suppression diode (TVS), unipolar or bipolar – used to absorb high-voltage spikes
Transient voltage suppression diode (TVS) These are avalanche diodes designed specifically to protect other semiconductor devices from high-voltage transients. [45] Their p–n junctions have a much larger cross-sectional area than those of a normal diode, allowing them to conduct large currents to ground without sustaining damage.
Z – Vacuum full-wave rectifier (dual power diode with common cathode) Following digits: model number and base type For signal pentodes, an odd model number most often identified a variable-mu (remote- cutoff ) tube, whereas an even number identified a 'high slope' (sharp-cutoff) tube
The following table compares cathode-ray tube (CRT), liquid-crystal display (LCD), plasma and organic light-emitting diode (OLED) display device technologies. These are the most often used technologies for television and computer displays.
When a small voltage is applied across the electrodes, only a tiny current flows, caused by reverse leakage through the diode junctions. When a large voltage is applied, the diode junction breaks down due to a combination of thermionic emission and electron tunneling, resulting in a large current flow. The result of this behavior is a nonlinear ...
Zener diodes have a low breakdown voltage. A standard value for breakdown voltage is for instance 5.6 V. This means that the voltage at the cathode cannot be more than about 5.6 V higher than the voltage at the anode (though there is a slight rise with current), because the diode breaks down, and therefore conducts, if the voltage gets any higher.