Search results
Results from the WOW.Com Content Network
Opel engine codes explained 1. = Emissions controls 2./3. = Displacement (in tenths of liters) 4. = Compression ratio 5. = Fuel feed (only on gasoline engines) 5./6. = Special conditions
When the computer detected a fault, it illuminated the MIL. Up until OBDII, on most cars the MIL could output codes. When two pins on the ALDL are jumped, the light would flash the codes, for instance (blink) (pause) (blink) (blink) for code 12. Some manufacturers, such as Honda, retained this feature even after OBDII.
Originally debuting as either a 1.0 L (973 cc) straight-3 or 1.2 L (1,199 cc) straight-4; a 1.4 L (1,364 cc) I4 variant was added with the introduction of the second generation, replacing the 1.4 L Family 1 engine. The Family 0 engines were produced by Opel Wien in Vienna/Aspern (Austria), by GM in Bupyeong (Korea) and Flint (Michigan, USA).
OBD-II PIDs (On-board diagnostics Parameter IDs) are codes used to request data from a vehicle, used as a diagnostic tool.. SAE standard J1979 defines many OBD-II PIDs. All on-road vehicles and trucks sold in North America are required to support a subset of these codes, primarily for state mandated emissions inspections.
Family 0 (1.0 – 1.4 L) Medium Gasoline Engine (1.6 – 1.8 L) The GM Family I is a straight-four piston engine that was developed by Opel , a former subsidiary of General Motors and now a subsidiary of PSA Group , to replace the Vauxhall OHV, Opel OHV and the smaller capacity Opel CIH engines for use on small to mid-range cars from Opel ...
The 1.6 L (1,584 cc) version has a 85 mm (3.35 in) bore and the same 69.8 mm (2.75 in) stroke as most CIH fours. It was introduced in September 1970 with the all new Opel Manta A and then, seven weeks later, in the Opel Ascona A. As with the 1.5 litre, a 16N for lower octane fuel and a more powerful 16S for higher octane fuel were offered.
It features a Bosch Motronic 2.8.1 engine management system (Omega), with later examples featuring M2.8.3 (Calibra 1994, Vectra 1995) and a compression ratio of 10.8:1. For 1994, in order to meet more stringent emissions requirements, a secondary air injection system and an EGR valve were added to the C25XE and it became the X25XE .
The 2019 facelift of the Opel/Vauxhall Astra K included a new 1.2 3-cylinder turbo with 110, 130 or 145 hp but this is not the PSA PureTech engine. This engine is part of GM ’s E-Turbo range and had already been extensively developed at by GM for the 2019 Astra before PSA purchased the company.