Search results
Results from the WOW.Com Content Network
Motherboard of the NeXTcube from 1990 having a Motorola 68040 (25 MHz) and a digital signal processor Motorola 56001 with 25 MHz which was directly accessible via an interface. In most designs the 56000 is dedicated to one single task, because digital signal processing using special hardware is mostly real-time and does not allow any interruption .
The result was the Network Test Automation Forum entity, which was set up in 2010 following the first face-to-face meeting in Montreal. [3] [4] [5] The NTAF (Network Testing Automation Framework) aims to streamline and enhance the interconnection of commercial testing tools and data communications infrastructure within the telecommunications ...
Here are the ways a modem can switch to data mode: After a successful dial-out connection in response to an "ATD" dial command in which the modem reaches another modem. After answering the phone with the "ATA" answer command, if another modem is on the other end.
The modem connects to a single computer or router, through an Ethernet port, USB port, or is installed in a computer PCI slot. The more common DSL router is a standalone device that combines the function of a DSL modem and a router, and can connect multiple computers through multiple Ethernet ports or an integral wireless access point.
The network controller implements the electronic circuitry required to communicate using a specific physical layer and data link layer standard such as Ethernet or Wi-Fi. [a] This provides a base for a full network protocol stack, allowing communication among computers on the same local area network (LAN) and large-scale network communications through routable protocols, such as Internet ...
In network topology, a cable modem is a network bridge that conforms to IEEE 802.1D for Ethernet networking (with some modifications). The cable modem bridges Ethernet frames between a customer LAN and the coax network. Technically, it is a modem because it must modulate data to transmit it over the cable network, and it must demodulate data ...
When the modem wants the computer to temporarily pause so the playback can catch up, it temporarily lowers the CTS (Clear to Send) signal on the RS-232 serial port. The modem re-raises the signal in time for the computer to resume sending audio data before the playback buffer becomes completely empty.
A DSL modem, which is type of customer-premises equipment. The WAN interface of this device, in this case the DSL port, could expose CWMP to the internet service provider . Technical Report 069 ( TR-069 ) is a document by the Broadband Forum that specifies the CPE WAN Management Protocol ( CWMP ).