Search results
Results from the WOW.Com Content Network
For most audio applications more power is needed at low frequencies. This requires a high-power amplifier for low frequencies (e.g., 200 watts for 20–200 Hz band), lower power amplifier for the midrange (e.g., 50 watts for 200 to 1000 Hz), and even less the high end (e.g. 5 watts for 1000–20000 Hz).
Audio stereo power amplifier made by McIntosh The internal view of a Mission Cyrus 1 Hi Fi integrated audio amplifier (1984) [1]. An audio power amplifier (or power amp) amplifies low-power electronic audio signals, such as the signal from a radio receiver or an electric guitar pickup, to a level that is high enough for driving loudspeakers or headphones.
From about 1900 to the 1950s, the "lowest frequency in practical use" in recordings, broadcasting and music playback was 100 Hz. [9] When sound was developed for motion pictures, the basic RCA sound system was a single 8-inch (20 cm) speaker mounted in straight horn, an approach which was deemed unsatisfactory by Hollywood decisionmakers, who hired Western Electric engineers to develop a ...
The output (plate) impedance of the diode vacuum tube rectifiers in the power supply is high, so the increasing impedance of the filter capacitors at low frequencies can mean that low frequency swings in the current drawn by output stages can cause voltage swings in the power supply voltage which feed back to earlier stages, [2] [6] [4] making ...
The high impedance of the line in circuit does not load down the output of the source device. These are voltage signals (as opposed to current signals) and it is the signal information (voltage) that is desired, not power to drive a transducer, such as a speaker or antenna. The actual information that is exchanged between the devices is the ...
The voltage is constant only in the sense that at full power, the voltage in the system does not depend on the number of speakers driven (as long the amplifier's maximum power is not exceeded). [2] Constant-voltage speaker systems are also commonly referred to as 25- , 70- , 70.7- , 100 or 210-volt speaker systems ; distributed speaker systems ...
An amplifier, electronic amplifier or (informally) amp is an electronic device that can increase the magnitude of a signal (a time-varying voltage or current). It is a two-port electronic circuit that uses electric power from a power supply to increase the amplitude (magnitude of the voltage or current) of a signal applied to its input ...
Most professional audio power amplifiers also provide protection from clipping typically as some form of limiting. A power amplifier pushed into clipping can damage loudspeakers. Amplifiers also typically provide protection against short circuits across the output and overheating. Audio engineers select amplifiers that provide enough headroom.