Search results
Results from the WOW.Com Content Network
For example, a single link PCIe 3.0 interface has an 8 Gbit/s transfer rate, yet its usable bandwidth is only about 7.88 Gbit/s. z Uses 8b/10b encoding, meaning that 20% of each transfer is used by the interface instead of carrying data from between the hardware components at each end of the interface. For example, a single link PCIe 1.0 has a ...
CAN FD (Controller Area Network Flexible Data-Rate) is a data-communication protocol used for broadcasting sensor data and control information on 2 wire interconnections between different parts of electronic instrumentation and control system. This protocol is used in modern high performance vehicles.
It can be used for applications inside or outside the car. The serial MOST bus uses a daisy-chain topology or ring topology and synchronous serial communication to transport audio, video, voice and data signals via plastic optical fiber (POF) (MOST25, MOST150) or electrical conductor (MOST50, MOST150) physical layers.
CAN FD (Flexible Data-Rate), standardized as ISO 11898-1, was developed by Bosch and released in 2012 to meet the need for increased data transfer in modern high-performance vehicles. It offers variable data rates during the transmission of a single frame, allowing the arbitration phase to occur at a lower data rate for robust communication ...
FlexRay is a communication bus designed to ensure high data rates, fault tolerance, operating on a time cycle, split into static and dynamic segments for event-triggered and time-triggered communications. It is mainly used in aeronautic and automotive sectors.
The network designer has to ensure the fault-free functionality in the design phase (one slave is allowed to send data to the bus in one frame time). If the identifier causes one physical LIN slave to send the response, the identifier may be called a Rx-identifier. If the master's slave task sends data to the bus, it may be called Tx-identifier.
Known as an input speed sensor (ISS). This sensor sends a varying frequency signal to the TCU to determine the current rotational speed of the input shaft or torque converter. The TCU uses the input shaft speed to determine slippage across the torque converter and potentially to determine the rate of slippage across the bands and clutches. This ...
The ISQ symbols for the bit and byte are bit and B, respectively.In the context of data-rate units, one byte consists of 8 bits, and is synonymous with the unit octet.The abbreviation bps is often used to mean bit/s, so that when a 1 Mbps connection is advertised, it usually means that the maximum achievable bandwidth is 1 Mbit/s (one million bits per second), which is 0.125 MB/s (megabyte per ...