Search results
Results from the WOW.Com Content Network
The flat parallel plug blades are polarized to prevent the hot and the neutral connections from being reversed. In addition, many versions have a molded obstruction bump on top of the adapter, to block the grounding prong and thus physically prevent forcible insertion of a 3-prong plug in the wrong orientation. [citation needed]
Double insulated appliances may omit the earth pin. When viewing a plug from the rear, and the earth pin downwards, the top left pin is active and the top right pin is neutral. The shank of the active and neutral pins of every 10 amp and 15 amp flat-pin plug sold after 3 April 2005 are required to be insulated, in accordance with AS/NZS 3112: ...
Detonation cord will initiate most commercial high explosives (dynamite, gelignite, sensitised gels, etc.) but will not initiate less sensitive blasting agents like ANFO on its own. 25 to 50 grain/foot (5.3 to 10.6 g/m) detonation cord has approximately the same initiating power as a #8 blasting cap in every 2 to 4 inches (5 to 10 cm) along its ...
The pilot pin is located in the centre of main contact circle on 4- and 5-pin connectors. On 3-pin (2P+E) connectors, it is located on the contact circle opposite the ground pin. The other connectors are located 105° on either side of the earth pin, rather than 120° as in the smaller variants, to make room for the pilot pin.
The connection may be removable (as for portable equipment), require a tool for assembly and removal, or serve as a permanent electrical joint between two points. [2] An adapter can be used to join dissimilar connectors. Most electrical connectors have a gender – i.e. the male component, called a plug, connects to the female component, or socket.
The addition is a 3 ⁄ 16-inch (4.8 mm) diameter round or U-shaped ground pin, 1 ⁄ 8 in (3.2 mm) longer than the power blades (so the device is grounded before the power is connected) and located from them by 1 ⁄ 4 in (6.4 mm) edge-to-edge or 15 ⁄ 32 in (11.9 mm) center-to-center.
The term plug is in general and technical use in all forms of English, common alternatives being power plug, [3] electric plug, [4] and plug top. [5] The normal technical term for an AC power socket is socket-outlet , [ 6 ] but in non-technical common use a number of other terms are used.
1×6 pin header (one row) 1×6 female header (one row) A pin header (or simply, header) is a form of electrical connector. A male pin header consists of one or more rows of metal pins molded into a plastic base, often 2.54 mm (0.1 in) apart, though available in many spacings. [1] Male pin headers are cost-effective due to their simplicity.