Search results
Results from the WOW.Com Content Network
[1] The Charrière is measured by the ''outer'' diameter, and is defined as 1 Fr = 1/3 mm, and thus 1 mm = 3 Fr; therefore the diameter of a round catheter in millimetres can be determined by dividing the French size by 3. [2] The French units roughly correspond to the outer circumference of the catheter (see table below).
Very close to wargaming 20 mm figure scale (20 mm is actually 1:80.5). [10] 1:76.2: 4 mm: Model railways (00) UK model rail scale 4 mm scale (OO Scale, etc.). 1:76: 4.011 mm: Model railways (00) Military models. Military vehicles. Used with 4 mm to 1 foot models as well. 1:75: 4.064 mm Used by Heller for model ships. Also some Japanese aircraft ...
For Morse taper-shank drill bits, the standard continues in 1/64 inch increments up to 1¾ inch, then 1/32 inch increments up to 2¼ inch, 1/16 inch increments up to 3 inches, 1/8 inch increments up to 3¼ inches, and a single 1/4 inch increment to 3½ inches. One aspect of this method of sizing is that the size increment between drill bits ...
In the United States, Canada, and Mexico, ring sizes are specified using a numerical scale with 1⁄4 steps, where whole sizes differ by 0.032 inches (0.81 mm) of internal diameter, equivalent to 0.1005 inches (2.55 mm) of internal circumference. The relationship of this size ( ) to ISO 8653:2016 circumference ( ) is , while the relationship to ...
2.12 mm = 1 ⁄ 4 of a barleycorn, [13] (thus 1 ⁄ 12 of an inch). Barleycorn: 8.47 mm = 1 ⁄ 3 of an inch, the notional base unit under the Composition of Yards and Perches. Digit: 19.05 mm = 3 ⁄ 4 inch Finger: 22.23 mm = 7 ⁄ 8 inch Inch: 25.4 mm: 3 barleycorns (the historical legal definition) Nail (cloth) 57.15 mm: 3 digits = 2 + 1 ...
British Standard Whitworth. British Standard Whitworth (BSW) is an imperial-unit -based screw thread standard, devised and specified by Joseph Whitworth in 1841 and later adopted as a British Standard. It was the world's first national screw thread standard, and is the basis for many other standards, such as BSF, BSP, BSCon, and BSCopper.
Mesh is a measurement of particle size often used in determining the particle-size distribution of a granular material. For example, a sample from a truckload of peanuts may be placed atop a mesh with 5 mm openings. When the mesh is shaken, small broken pieces and dust pass through the mesh while whole peanuts are retained on the mesh.
Conversions between units in the metric system are defined by their prefixes (for example, 1 kilogram = 1000 grams, 1 milligram = 0.001 grams) and are thus not listed in this article. Exceptions are made if the unit is commonly known by another name (for example, 1 micron = 10 −6 metre).