Search results
Results from the WOW.Com Content Network
Conversion of units is the conversion of the unit of measurement in which a quantity is expressed, typically through a multiplicative conversion factor that changes the unit without changing the quantity. This is also often loosely taken to include replacement of a quantity with a corresponding quantity that describes the same physical property ...
Hydraulic conductivity. In science and engineering, hydraulic conductivity (K, in SI units of meters per second), is a property of porous materials, soils and rocks, that describes the ease with which a fluid (usually water) can move through the pore space, or fracture network. [1]
The recent formula used by the Brannock device assumes a foot length of 2 barleycorns less than the length of the last; thus, men's size 1 is equivalent to a last's length of 8 + 1 ⁄ 3 in (21.17 cm) and foot's length of 7 + 2 ⁄ 3 in (19.47 cm), and children's size 1 is equivalent to 4 + 1 ⁄ 4 in (10.8 cm) last's length and 3 + 7 ⁄ 12 in ...
Basal area is the cross-sectional area of trees at breast height (1.3m or 4.5 ft above ground). It is a common way to describe stand density. In forest management, basal area usually refers to merchantable timber and is given on a per hectare or per acre basis.
The centimetre–gram–second system of units (CGS or cgs) is a variant of the metric system based on the centimetre as the unit of length, the gram as the unit of mass, and the second as the unit of time. All CGS mechanical units are unambiguously derived from these three base units, but there are several different ways in which the CGS ...
statvolt (CGS unit) statV. ≘ c ⋅ (1 μJ/A⋅m) = 299.792458V. volt (SI unit) V. The difference in electric potential across two points along a conducting wire carrying one ampere of constant current when the power dissipated between the points equals one watt. [ 32 ] = 1 V = 1 W/A = 1 kg⋅m2/ (A⋅s3) = 1 J/C.
An input unit can be converted to any number of output units—the outputs are specified as a "combination" by separating unit codes with a space (" ") or a plus (" + "). Using a space as a separator does not work if any of the unit codes contains a space. For example, each of the following converts 1.2 km 2 to acres, square yards, and hectares.
Length. For measuring length, the U.S. customary system uses the inch, foot, yard, and mile, which are the only four customary length measurements in everyday use. From 1893, the foot was legally defined as exactly 1200⁄3937 m (approximately 0.304 8006 m). [13] Since July 1, 1959, the units of length have been defined on the basis of 1 yd = 0 ...