enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Idler-wheel - Wikipedia

   en.wikipedia.org/wiki/Idler-wheel

   In a belt drive system, idlers are often used to alter the path of the belt, where a direct path would be impractical. Idler pulleys are also often used to press against the back of a pulley in order to increase the wrap angle (and thus contact area) of a belt against the working pulleys, increasing the force-transfer capacity.

3. Pulley - Wikipedia

   en.wikipedia.org/wiki/Pulley

   Flat belt on a belt pulley Belt and pulley system Cone pulley driven from above by a line shaft. A belt and pulley system is characterized by two or more pulleys in common to a belt. This allows for mechanical power, torque, and speed to be transmitted across axles. If the pulleys are of differing diameters, a mechanical advantage is realized.

4. Belt-driven bicycle - Wikipedia

   en.wikipedia.org/wiki/Belt-driven_bicycle

   Gates bike belt drive system Belt-drive Belt-drive single-speed rear hub on a Trek District Belt-drive crankset on a Trek District Belt-drive multi-speed rear hub gear on a Trek Soho. A belt-driven bicycle is a chainless bicycle that uses a flexible belt, typically a synchronous toothed design, in order to transmit power from the pedals to the ...

5. Belt (mechanical) - Wikipedia

   en.wikipedia.org/wiki/Belt_(mechanical)

   The open belt drive has parallel shafts rotating in the same direction, whereas the cross-belt drive also bears parallel shafts but rotate in opposite direction. The former is far more common, and the latter not appropriate for timing and standard V-belts unless there is a twist between each pulley so that the pulleys only contact the same belt ...

6. Positive locking device - Wikipedia

   en.wikipedia.org/wiki/Positive_locking_device

   A positive locking device is a device used in conjunction with a fastener in order to positively lock the fastener. This means that the fastener cannot work loose from vibrations. The following is a list of positive locking devices: [1] A split beam nut; A castellated nut and a split pin; A hex nut or cap screw and a tab washer

7. Glossary of locksmithing terms - Wikipedia

   en.wikipedia.org/wiki/Glossary_of_locksmithing_terms

   The lock housing is the part of the lock that does not move when the lock is opened. It is responsible for transferring the action of the key to the bolt. [7] Master pin In a pin tumbler lock, a master pin is an optional, usually short, disk-like pin placed between the top and bottom pins. Its purpose is to allow two differently-cut keys to ...