enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Tygon tubing - Wikipedia

   en.wikipedia.org/wiki/Tygon_Tubing

   There are many formulations of clear, flexible, Tygon tubing. The chemical resistance and physical properties vary among the different formulations, but the tubing generally is intended to be "so resistant to chemical attack that it will handle practically any chemical", whether liquid, gas, or slurry. [ 2 ]

3. Rubber cement - Wikipedia

   en.wikipedia.org/wiki/Rubber_cement

   Rubber cement (cow gum in British English) is an adhesive made from elastic polymers (typically latex) mixed in a solvent such as acetone, hexane, heptane or toluene to keep it fluid enough to be used. This makes it part of the class of drying adhesives: as the solvents quickly evaporate, the rubber solidifies, forming a strong yet flexible bond.

4. Tube (fluid conveyance) - Wikipedia

   en.wikipedia.org/wiki/Tube_(fluid_conveyance)

   Both pipe and tube imply a level of rigidity and permanence, whereas a hose is usually portable and flexible. A tube and pipe may be specified by standard pipe size designations, e.g., nominal pipe size, or by nominal outside or inside diameter and/or wall thickness. The actual dimensions of pipe are usually not the nominal dimensions: A 1-inch ...

5. Synthetic rubber - Wikipedia

   en.wikipedia.org/wiki/Synthetic_rubber

   Synthetic rubber, like most other polymers, is made from various petroleum-based monomers. Some synthetic rubbers are less sensitive to ozone cracking than natural rubber. Natural rubber is sensitive because of the double bonds in its chain structure, but some synthetic rubbers do not possess these bonds and so are more resistant to ozone cracking.

6. Rubber band - Wikipedia

   en.wikipedia.org/wiki/Rubber_band

   [1] [2] [3] Most rubber bands are manufactured out of natural rubber as well as for latex free rubber bands or, especially at larger sizes, an elastomer, and are sold in a variety of sizes. Notable developments in the evolution of rubber bands began in 1923 when William H. Spencer obtained a few Goodyear inner tubes and cut the bands by hand in ...

7. Polybutadiene - Wikipedia

   en.wikipedia.org/wiki/Polybutadiene

   Polybutadiene rubber is seldom used alone, but is instead mixed with other rubbers. Polybutadiene is difficult to band in a two roll mixing mill. Instead, a thin sheet of polybutadiene may be prepared and kept separate. Then, after proper mastication of natural rubber, the polybutadiene rubber may be added to the two roll mixing mill.

8. Rubber pad forming - Wikipedia

   en.wikipedia.org/wiki/Rubber_pad_forming

   Rubber pad forming process, 1: bottom of the press. 2: lower die. 3: sheet metal. 4: rubber pad. 5: top of the press. Rubber pad forming (RPF) is a metalworking process where sheet metal is pressed between a die and a rubber block, made of polyurethane. Under pressure, the rubber and sheet metal are driven into the die and conform to its shape ...

9. Hose clamp - Wikipedia

   en.wikipedia.org/wiki/Hose_clamp

   The clamp is placed over the end of the hose or tube to be connected and when each ear is closed at the base of the ear with a special pincer tool, it permanently deforms, pulling the band, and causing the band to tighten around the hose. The size of clamp should be chosen such that the ear(s) are almost completely closed on installation.