enow.com Web Search

  1. Ads

    related to: pressure altitude correction chart for water heater pump circulation pumps

Search results

  1. Results from the WOW.Com Content Network
  2. Circulator pump - Wikipedia

    en.wikipedia.org/wiki/Circulator_pump

    By installing a thermostatically controlled pump just after the farthest fixture on the loop, cyclic pumping maintains ready hot water up to the last fixture on the loop instead of wasting energy heating the piping from the last fixture to the water heater. Installing a circulation pump at the farthest fixture on a hot water circulation loop is ...

  3. Pressure altitude - Wikipedia

    en.wikipedia.org/wiki/Pressure_altitude

    It indicates altitude obtained when an altimeter is set to an agreed baseline pressure under certain circumstances in which the aircraft’s altimeter would be unable to give a useful altitude readout. Examples would be landing at a high altitude or near sea level under conditions of exceptionally high air pressure.

  4. Comparison of pumps - Wikipedia

    en.wikipedia.org/wiki/Comparison_of_pumps

    Different types of pumps are suitable for different applications, for example: a pump's maximum lift height also determines the applications it can be used for. Low-lift pumps are only suitable for the pumping of surface water (e.g., irrigation, drainage of lands, ...), while high-lift pumps allow deep water pumping (e.g., potable water pumping ...

  5. Circulating water plant - Wikipedia

    en.wikipedia.org/wiki/Circulating_Water_Plant

    Horizontal, centrifugal pumps for clear, cold fresh water 4 IS: 1536 Centrifugally cast (spun) iron pressure pipes for water, gas and sewage 5 IS: 1537 Vertically cast iron pressure pipes for water, gas and sewage 6 IS: 1710 Vertical turbine pumps for clear, cold fresh water 7 IS: 2002 Steel plates for boilers 8 IS: 2062

  6. Net positive suction head - Wikipedia

    en.wikipedia.org/wiki/Net_positive_suction_head

    Example Number 1: A tank with a liquid level 2 metres above the pump intake, plus the atmospheric pressure of 10 metres, minus a 2 metre friction loss into the pump (say for pipe & valve loss), minus the NPSH R curve (say 2.5 metres) of the pre-designed pump (see the manufacturers curve) = an NPSH A (available) of 7.5 metres. (not forgetting ...

  7. Forced circulation boiler - Wikipedia

    en.wikipedia.org/wiki/Forced_circulation_boiler

    The secondary pump takes the feed water going to the boiler and raises the pressure of the water going in. In a natural circulation boilers, the circulation of water is dependent on the differential pressures caused by the change of density in the water as it is heated. That is to say that as the water is heated and starts turning to steam, the ...

  1. Ads

    related to: pressure altitude correction chart for water heater pump circulation pumps