Ads
related to: dana 20 transfer case patternebay.com has been visited by 1M+ users in the past month
powertrainproducts.net has been visited by 10K+ users in the past month
Search results
Results from the WOW.Com Content Network
The Dana 20 can be identified by the center rear output, cast iron construction, and deep oil pan. Like the Dana 18, it uses the Texas bolt pattern to hold the transfer case in place. This is a heavy-duty, gear-driven part-time [2] transfer case with a 26-tooth input gear. The output for the front drive shaft is on the right side and the rear ...
Command-Trac was first introduced using the NP208 transfer case in the full-size Jeeps (SJ series) in 1980. The drive modes are the same as with the Dana 18 and 20 transfer cases: 2Hi, 4HI PT, and 4LO PT. The 4WD modes are not for use on high-traction surfaces such as dry roads. The NP208 was used through at least 1987.
A gear-driven Dana 20 transfer case with 2.03:1 low range was standard with the manual gearbox (which had a much lower first gear of 6.3:1), while the TH400 automatics received the permanent four-wheel-drive QuadraTrac system. The chain-driven, aluminum QuadraTrac was advanced at the time.
From 1976 through 1980, the CJ-7 came equipped with a Dana 20 transfer case, Dana 30 front axle (27- or 31-spline), and a 29-spline AMC 20 rear axle, while in later years, Laredo packages added a tachometer, chrome bumpers, tow hooks, and interior upgrades including leather seats and clock.
Both front and rear differentials were offset to the passenger side for the purpose of lining up the drive shafts with the Dana 18 transfer case. With the transition to the 800A model, the rear axle was upgraded to a Dana 44, with a centered differential mated to a Dana 20 transfer case. Some Scouts from this transitional period use a mix of ...
Get the Gainesville, GA local weather forecast by the hour and the next 10 days.
Transmission, axle, and transfer case choices were carried over from the previous models. However, major changes were underway with a new executive, Wolfgang Bernhard , who was known as a "cost-slasher" nicknamed "whirlwind", who came from Mercedes-Benz to turn Chrysler around.
Also called the GM small corporate pattern and the S10 pattern. This pattern has a distinctive odd-sided hexagonal shape. Rear wheel drive applications have the starter mounted on the right side of the block (when viewed from the flywheel) and on the opposite side of the block compared to front wheel drive installations.
Ads
related to: dana 20 transfer case patternebay.com has been visited by 1M+ users in the past month
powertrainproducts.net has been visited by 10K+ users in the past month