enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. HomePNA - Wikipedia

   en.wikipedia.org/wiki/HomePNA

   HomePNA 3.1 was developed by Coppergate Communications [2] and was approved by the ITU as Recommendation G.9954 in January 2007. HomePNA 3.1 added Ethernet over coax . HomePNA 3.1 uses frequencies above those used for digital subscriber line and analog voice calls over phone wires and below those used for broadcast and direct-broadcast ...

3. Fiber-optic splitter - Wikipedia

   en.wikipedia.org/wiki/Fiber-optic_splitter

   The FBT splitter is one of the most common. FBT splitters are widely accepted and used in passive networks, especially for instances where the split configuration is smaller (1×2, 1×4, 2×2, etc.). [1] The PLC is a more recent technology. PLC splitters offer a better solution for larger applications.

4. CoaXPress - Wikipedia

   en.wikipedia.org/wiki/CoaXPress

   It is also possible to reuse existing coaxial cable when upgrading from an analogue to a digital camera system. The original connector for CoaXPress is a 75 Ω IEC 61169-8 BNC connector . The smaller DIN 1.0/2.3 connector was added in CoaXPress 1.1, and the Micro-BNC connector was then added to CoaXPress 2.0 for the new speeds faster than CXP-6.

5. Belling-Lee connector - Wikipedia

   en.wikipedia.org/wiki/Belling-Lee_connector

   Female Belling-Lee connector on a television set. The Belling-Lee connector (also type 9,52, but largely only in the context of its specification, IEC 61169, Part 2: Radio-frequency coaxial connector of type 9,52) [1] is commonly used in Europe, parts of Southeast Asia, and Australia, to connect coaxial cables with each other and with terrestrial VHF/UHF roof antennas, antenna signal ...

6. Y-cable - Wikipedia

   en.wikipedia.org/wiki/Y-cable

   A Shure FP24 preamp's mono XLR line outputs connected to an Edirol R-09 recorder's 3.5mm stereo jack line input, using a Y-cable. This is an example of consolidating connectors, as described below. A Y-cable, Y cable, or splitter cable is a cable with three ends: one common end and two other ends. The Y-cable can resemble the Latin letter "Y".

7. Diplexer - Wikipedia

   en.wikipedia.org/wiki/Diplexer

   A diplexer allows two different devices to share a common communications channel. Typically, the channel is a long coaxial cable, and a diplexer is often used at both ends of the coaxial cable. The plan is feasible if the two devices operate on different frequencies. The plan is economical if the diplexers cost less than running a second cable.