Search results
Results from the WOW.Com Content Network
Valves of this type using a cylinder rather than a cone are sometimes encountered, but using a cone allows a tight fit to be made even with moderate manufacturing tolerances. The ball in ball valves rotates within plastic (usually PTFE) seats. Hands free infrared proximity sensors are replacing the standard valve. Thermostatically controlled ...
Copper fittings for soldered joints. Pipe fittings: 1) Copper (solder); 2) Iron or brass (threaded); 3) Brass (compression); 4) Brass (compression to solder); 5) Brass adapters. PVC fittings. A fitting or adapter is used in pipe systems to connect sections of pipe (designated by nominal size, with greater tolerances of variance) or tube ...
These valves are normally left open so that the user can control the flow of water with the spigot above the sink, and does not need to reach under the counter to start or stop the water flow. However, if the spigot needs to be replaced (i.e. maintenance needs to take place on the system), the isolation valves are shut to stop the flow of water ...
A faucet aerator can be classified on the basis of its flow rate and the type of water stream (aerated, non-aerated, spray) it produces. In general, standard-sized aerators are available with female (M22x1) or male threading (M24x1). Bathtub spouts often have a bigger diameter with a male M28x1 thread. The United States uses different thread ...
Each fixture usually has a characteristic means of connection. Normal plumbing practice is to install a valve on each water supply line before the fixture, and this is most commonly termed a stop or "service valve". The water supply to some fixtures is cold water only (such as water closets and urinals). Most fixtures also have a hot water supply.
Ballcock. A ballcock (also balltap or float valve) is a mechanism or machine for filling water tanks, such as those found in flush toilets, while avoiding overflow and (in the event of low water pressure) backflow. The modern ballcock was invented by José Antonio de Alzate y Ramírez, a Mexican priest and scientist, who described the device in ...
A thermostatic mixing valve (TMV) is a valve that blends hot water with cold water to ensure constant, safe shower and bath outlet temperatures to prevent scalding. The storage of water at high temperature removes one possible breeding ground for Legionella; the use of a thermostat, rather than a static mixing valve, provides increased safety ...
Plumbing. A complex arrangement of rigid steel piping and stop valves regulate flow to various parts of the building, with an evident preference for right-angle pipe bends and orthogonal pipe routes. Plumbing is any system that conveys fluids for a wide range of applications.