Search results
Results from the WOW.Com Content Network
DOCSIS 3.0, 3.1 — 5 1 × 2.5 gigabit, 4 × gigabit ... Supported speed and bands depend on the hardware version. ... features an additional Ethernet port for WAN ...
DOCSIS employs a mixture of deterministic access methods for upstream transmissions, specifically time-division multiple access (TDMA) for DOCSIS 1.0/1.1 and both TDMA and S-CDMA for DOCSIS 2.0 and 3.0, with a limited use of contention for bandwidth reservation requests. In TDMA, a cable modem requests a time to transmit and the CMTS grants it ...
Data Over Cable Service Interface Specification Provisioning of Ethernet Passive Optical Network, or DPoE, is a set of CableLabs specifications that implement the DOCSIS service layer interface on existing Ethernet PON (EPON, GEPON or 10G-EPON) media access control (MAC) and physical layer (PHY) standards. In short it implements the DOCSIS ...
This is a list of interface bit rates, is a measure of information transfer rates, or digital bandwidth capacity, at which digital interfaces in a computer or network can communicate over various kinds of buses and channels.
The industry has made a concerted effort to resolve the limitations of Ethernet in the WAN described above, so as to allow the use of "native" Ethernet technologies by network providers. [ citation needed ] The key roles have been played by the Institute of Electrical and Electronics Engineers (IEEE) 802.1 and 802.3 standards committees.
A different slave becomes active if, and only if, the active slave fails. The single logical bonded interface's MAC address is externally visible on only one NIC (port) to simplify forwarding in the network switch. This mode provides fault tolerance. XOR (balance-xor) Transmit network packets based on a hash of the packet's source and destination.
By reducing the original signal rate to 1 ⁄ 4 or 1 ⁄ 2, the link speed drops to 2.5 or 5 Gbit/s, respectively. [5] The spectral bandwidth of the signal is reduced accordingly, lowering the requirements on the cabling, so that 2.5GBASE-T and 5GBASE-T can be deployed at a cable length of up to 100 m on Cat 5e or better cables. [6] [7]
Many Ethernet adapters and switch ports support multiple speeds by using autonegotiation to set the speed and duplex for the best values supported by both connected devices. If autonegotiation fails, some multiple-speed devices sense the speed used by their partner, [ 1 ] but this may result in a duplex mismatch .