Search results
Results from the WOW.Com Content Network
Rack with sample component sizes including an A/V half-rack unit. A rack unit (abbreviated U or RU) is a unit of measure defined as 1 + 3 ⁄ 4 inches (44.45 mm). [1] [2] It is most frequently used as a measurement of the overall height of 19-inch and 23-inch rack frames, as well as the height of equipment that mounts in these frames, whereby the height of the frame or equipment is expressed ...
Thus, a 1U rackmount computer is not 1.750 inches (44.5 mm) tall but is 1.719 inches (43.7 mm) tall. If n is number of rack units, the ideal formula for panel height is h = 1.75n − 0.031 for calculating in inches, and h = 44.45n − 0.794 for calculating in millimeters. This gap allows a bit of room above and below an installed piece of ...
In form-factor there are two models: half-height and full-height. In an enclosure you can fit 8 full or 16 half-height blades (or a mix). Each server has two or four on-board NIC's and two additional Mezzanine card -slots for additional I/O options: 1 Gb or 10 Gb Ethernet cards, Fibre Channel HBA 's or InfiniBand slots.
Drilling Formula Sheets is a set of Drilling Formulas used commonly by drilling engineers in the onshore and offshore oil drilling industry. They are used as part of a key piece of engineering work called Well Control .
3U (5.06 inches or 128.5 mm), where height "U" is measured in rack units, rounded for a lip (nb: 3U in standard rack units would be 5.25 inches or 133.3 mm). 1HP (0.2 inches or 5.08 mm), where width "HP" is measured in horizontal pitch units. A card width is generally integer multiples of 1HP, although some manufactures work in multiples of 0.5HP.
A rack and pinion has roughly the same purpose as a worm gear with a rack replacing the gear, in that both convert torque to linear force. However the rack and pinion generally provides higher linear speed — since a full turn of the pinion displaces the rack by an amount equal to the pinion's pitch circle whereas a full rotation of the worm screw only displaces the rack by one tooth width.
However, the two most common forms are tower and rack-mount. [12] Tower models stand upright on the ground or on a desk or shelf, and are typically used in network workstations or desktop computer applications. Rack-mount models can be mounted in standard 19-inch rack enclosures and can require anywhere from 1U to 12U . They are typically used ...
In a helical rack, a normal plane is normal to all the teeth it intersects. In a helical gear, however, a plane can be normal to only one tooth at a point lying in the plane surface. At such a point, the normal plane contains the line normal to the tooth surface.