Search results
Results from the WOW.Com Content Network
When input and output impedances are the same, voltage attenuation will be the square root of power attenuation, so, for example, a 6 dB attenuator that reduces power to one fourth will reduce the voltage (and the current) by half. Nominal impedance, for example 50 ohm; Frequency bandwidth, for example DC-18 GHz
Monolithic microwave integrated circuit, or MMIC (sometimes pronounced "mimic"), is a type of integrated circuit (IC) device that operates at microwave frequencies (300 MHz to 300 GHz). These devices typically perform functions such as microwave mixing , power amplification, low-noise amplification , and high-frequency switching.
The input and output impedances at each port are designed to be equal to the characteristic impedance of the microwave system. This is achieved by making the line impedance 2 {\displaystyle \scriptstyle {\sqrt {2}}} of the system impedance – for a 50 Ω system the Wilkinson lines are approximately 70 Ω [ 27 ]
The power input to the transformer and output from the transformer is the same (except for conversion losses). The side with the lower voltage is at low impedance (because this has the lower number of turns), and the side with the higher voltage is at a higher impedance (as it has more turns in its coil).
The interface dimensions for SMA connectors are listed in MIL-STD-348. [5] The SMA connector employs a 1 ⁄ 4 inch diameter, 36-thread-per-inch threaded barrel. The male is equipped with a hex nut measuring 5 ⁄ 16 inch (0.3125 inch / 7.9 mm) across opposite flats, thus taking the same wrench as a #6 SAE hex nut.
In the field of radio frequency (RF) and microwave engineering, by far and away the most common transmission line standard is 50 Ω coaxial cable (coax), which is an unbalanced line. 50 Ω first arose as a nominal impedance during World War II work on radar and is a compromise between two requirements. This standard was the work of the wartime ...
In general a 50 ohm socket is not damaged by a 75 ohm pin, but the loose fit means the contact quality is not guaranteed; this can cause poor or intermittent operation, with the thin 75 ohm male pin only barely mating with the larger 50 ohm socket in the female. The 50 ohm type N connector is favored in microwave applications and microwave ...
If a quarter-wavelength of 75 Ohm coaxial cable is linked to a 50 Ohm load, the SWR in the 75 Ohm quarter wavelength of line can be calculated as 75Ω / 50Ω = 1.5; the quarter-wavelength of line transforms the mismatched impedance to 112.5 Ohms (75 Ohms × 1.5 = 112.5 Ohms). Thus this inserted section matches a 112 Ohm antenna to a 50 Ohm main ...