Search results
Results from the WOW.Com Content Network
It is referred to as non-volatile memory or NVRAM because, after the system loses power, it does retain state by virtue of the CMOS battery. When the battery fails, BIOS settings are reset to their defaults. The battery can also be used to power a real time clock (RTC) and the RTC, NVRAM and battery may be integrated into a single component.
This is often called the CMOS battery or BIOS battery. The original IBM AT through to the PS/2 range, used a relatively large primary lithium battery, compared to later models, to retain the clock and configuration memory. [2] These early machines required the backup battery to be replaced periodically due to the relatively large power consumption.
Later computers, including most IBM-compatibles with 80286 CPUs, had a battery-backed nonvolatile BIOS memory (CMOS RAM chip) that held BIOS settings. [48] These settings, such as video-adapter type, memory size, and hard-disk parameters, could only be configured by running a configuration program from a disk, not built into the ROM.
This is usually managed by the operating system's power management software or through the BIOS, thus different settings can be configured for laptop battery mode versus running from the battery charger. Low power mode is often achieved by reducing or even stopping the serial bus clock as well as possibly powering down the PHY device itself.
Advanced Configuration and Power Interface (ACPI) is an open standard that operating systems can use to discover and configure computer hardware components, to perform power management (e.g. putting unused hardware components to sleep), auto configuration (e.g. Plug and Play and hot swapping), and status monitoring.
APM defines five power states for the computer system: Full On: The computer is powered on, and no devices are in a power saving mode. APM Enabled: The computer is powered on, and APM is controlling device power management as needed. APM Standby: Most devices are in their low-power state, the CPU is slowed or stopped, and the system state is saved.
e820 is shorthand for the facility by which the BIOS of an x86-based computer system reports the memory map to the operating system or boot loader. [1] It is accessed via the int 15h call, by setting the AX register to value E820 in hexadecimal. It reports which memory address ranges are usable and which are reserved for use by the BIOS. [2]
Pages in category "Gateway, Inc. laptops" ... Gateway Solo This page was last edited on 15 May 2023, at 02:01 (UTC). Text is available under the Creative Commons ...