Ads
related to: sheet metal fender flares
Search results
Results from the WOW.Com Content Network
The similar front section between the door and the hood (bonnet) is called a fender (front wing), and may sometimes also be referred to as a quarter panel. [1] Quarter panels are typically made of sheet metal , but are sometimes made of fiberglass , carbon fiber , or fiber-reinforced plastic .
Even after the Dodge D series "Sweptline" pickup trucks with square fenders and flat windshields were released, the Town Wagons retained the 1958 sheet metal design of the C series pickups and LCF heavy-duty trucks.
Franco Scaglione handled these with particular genius - first by incorporating a hood scoop to lower the surrounding sheet metal, and then by incorporating sharply creased fender lines out over the wheels to draw the eye's attention away from the unusually tall peak in the hood. A few design changes were requested by S.H. Arnolt.
The Studebaker Coupe Express is a passenger car based coupe utility, produced by the Studebaker Corporation of South Bend, Indiana, between 1937 and 1939.Featuring an automobile styled cab and flared rear fenders right off the Studebaker Dictator, it was sold both with a manufacturer supplied pick up style metal bed, [1] and as a rolling chassis and cab to be fitted with a bed or boxes by the ...
A one-ton W300 light-duty/civilian type Power Wagon was released in 1958. This also had the styled cab and sheet metal as the D300 Medium duty one-ton trucks. The two-ton W500 Power Wagon (only a chassis cab was built) was introduced in 1956 as the C3-HW and lasted through the 1971 model year.
The doors and front fenders were re-shaped, eliminating the wheel arch bulge and replacing it with a more traditional character line in the sheet metal. The lower side crease line (which replaced the pre-facelift model's side chrome trim) extends from the rear door all the way to the front fender, hence all the side panels except for the rear ...
Ads
related to: sheet metal fender flares