enow.com Web Search

  1. Ads

    related to: what is elastic thickness of concrete sand wedge anchors

Search results

  1. Results from the WOW.Com Content Network
  2. Glossary of prestressed concrete terms - Wikipedia

    en.wikipedia.org/wiki/Glossary_of_prestressed...

    A formwork blockout or recess former fitted to the edge formwork of a post-tensioned concrete member, and that creates a temporary void space external to the prestressing anchor to allow the anchor block or similar to be fitted after formwork stripping. [3]: 32 anchor set See wedge set. anchorage assembly

  3. Concrete cone failure - Wikipedia

    en.wikipedia.org/wiki/Concrete_cone_failure

    Under tension loading, the concrete capacity of a single anchor is calculated assuming an inclination between the failure surface and surface of the concrete member of about 35°. The concrete cone failure load N 0 {\displaystyle N_{0}} of a single anchor in uncracked concrete unaffected by edge influences or overlapping cones of neighboring ...

  4. Tieback (geotechnical) - Wikipedia

    en.wikipedia.org/wiki/Tieback_(geotechnical)

    Grouted tiebacks can be constructed as steel rods drilled through a concrete wall out into the soil or bedrock on the other side. Grout is then pumped under pressure into the tieback anchor holes to increase soil resistance and thereby prevent tiebacks from pulling out, reducing the risk for wall destabilization.

  5. Properties of concrete - Wikipedia

    en.wikipedia.org/wiki/Properties_of_concrete

    The modulus of elasticity of concrete is relatively constant at low stress levels but starts decreasing at higher stress levels as matrix cracking develops. The elastic modulus of the hardened paste may be in the order of 10-30 GPa and aggregates about 45 to 85 GPa. The concrete composite is then in the range of 30 to 50 GPa.

  6. Anchor bolt - Wikipedia

    en.wikipedia.org/wiki/Anchor_bolt

    torque controlled: the anchor is inserted into the hole and secured by applying a specified torque to the bolt head or nut with a torque wrench. A particular sub-category of this anchor is called wedge type. As shown in the figure, tightening the bolt results in a wedge being driven up against a sleeve, which expands it and causes it to ...

  7. Wedge anchor - Wikipedia

    en.wikipedia.org/?title=Wedge_anchor&redirect=no

    This page was last edited on 19 February 2011, at 12:03 (UTC).; Text is available under the Creative Commons Attribution-ShareAlike License 4.0; additional terms may apply.

  1. Ads

    related to: what is elastic thickness of concrete sand wedge anchors